Chicago Electric 66619 manual See Figure C Start Procedure Before starting the Engine

FIGURE C

FUEL TANK CAP (76)

STRAINER

(74)

3.Remove the Fuel Tank Cap (76) and check the fuel level.

(See Figure C.)

WARNING! To prevent serious injury from fire:

Fill the Fuel Tank (73) in a well- ventilated area away from ignition

sources. Do not smoke.

4.To fill the Fuel Tank (73), first wipe off the

Fuel Tank Cap (76) and the surrounding area.

(See Figure C.)

5.Unscrew, and remove the Fuel Tank Cap (76). (See Figure C.)

6.Remove the Strainer (74) and remove any dirt and debris. Then replace the Strainer. (See Figure C.)

7.Fill the Fuel Tank (73) to about 1 inch under the fill neck of the Tank with the pre-mixed unleaded gasoline/2-cycle oil mixture.

8.Then replace the Fuel Tank Cap (76).

(See Figure C.)

Start Procedure:

Before starting the Engine:

a. Inspect the Generator and Engine.

b. Fill the Fuel Tank (73) with the proper amount and type of unleaded gasoline and 2-cycle oil.

(See Figures B and C.)

c. NOTE: Only after the Generator has stabilized and is running smoothly should an appliance or tool be plugged into the AC Outlet of the Generator.

FIGURE D

FUEL

SWITCH

(80)

“OPEN”

1.Turn the Engine Fuel Switch (80) to its “OPEN” position. (See Figure D.)

FIGURE E

CHOKE LEVER (82)

“RUN”

“CHOKE”

2.Turn the Engine Choke Lever (82) to its “CHOKE” position. Set the Choke Lever

SKU 66619 For technical questions, please call 1-800-444-3353. Page 10