3 ADJUST THE CLUTCH CONTROL
ABLES
_riodic adjustment of the cables may be required due to rmat stretch and wear on the bells Tocheck lor correct
justment, the control lever must be in the full forward
sition, restingontheptasticbumper Thecontrolcables
e correctly adiusted when the center of the 'Z'tilting is _tween the center and top of Ihe hole in the clutch lever _dthere is no droop in the cable (See Fig 23)
adjustmenl is necessary:
Disconnect "Z'Fitting lrom drive lever
Push the cable through the spring (See Fig 24) to expose the threaded portion of the cable
Hold the square end of the threaded portion with pliers and adjust the tocknut in or out until the excess slack is removed (See Fig 24)
Pull the cable back through the spring and connect the cable
Do the same for the other lever cable
OTE: Whenever the traction drive or auger belts are Jiusted or replaced, the cables w{IIneed to be adjusted
"O ADJUST BELTS
efts stretch during normal use If you need to adjust _e belts due to wear or stretch, proceed as follows:
,_UGER DRIVE BELT (See Fig_ 26)
your snow thrower will not discharge snow, check the :ontrol cable adjustment If it is correct, then check the ondition of the auger drive belt It may be loose or _amaged If it is damaged, replace it See To Replace :,ells paragraph on page 19 If the auger drive belt is rose, adjust as follows:
Disconnect the spark plug wire
Remove the belt cover (See Fig 27, page 19)
Loosen the nut on the auger idler pulley (See Fig 26) and move the pulley toward the belt about 1/8"
Tighten the nut
Press the auger drive lever Check the tension on the belt (opposite auger idler pulley) The belt should deflect about 112'"with moderate pressure (See Fig 25)
IOTE: You may have to move the auger idler pulley _ore than once to obtain the correct tension
Replace the be!t cover
Check the clutch control cable adjuslment
Reconnecf the spark plug wire
°RACTION DRIVE BELT
he traction drive bell has constanl spring pressure and Des not require adjustment
!8
AUGER | CONTROL LEVER |
MUST BE IN FULL |
LEVER
(Just cortt acting
I ORWARD PQsrrloN Plastic Bumper} WHEN
CHECKING
,PLASTIC BUMPER
FIG, 23
inlH,, | i, | lU | ,H,ll | u,,p | , | ,tllll |
END
LOCKNUT
FIG. 24
__DRIVE
POLLE,,
AUGERlULER----%) _.jF.---It2INCH
| \ | ' | ,/"_'_ IMPELLER |
|
|
|
| PULLEY |
|
ii i1[iiiiiiii | i I | I iiiiiiiiii | ii iiiiiill I | I |
FIG_ 25
;ACTION DRIVE
IDLER PULLEY
(Right
AUGER IDLER
PULLEY
FIG, 26
•Replace the traction drive belt it it is slipping (see To Replace Belts paragraph on page !9)