Sears 536.886531 owner manual Safety Rules, Engine Before, Unclogging, Maintenance and Storage

Page 3

SAFETY RULES

8.Do not run the engine indoors, except when starting the engine and for transporting the snow thrower in or out of the building. Open the outside doors; exhaust lumesaredangerous (containing CARBON MONOXIDE, an ODORLESS and DEADLY GAS).

9.Do not clear snow across the face of slopes. Exercise caution when changing direction on slopes. Do not attempt to clear steep slopes.

10.Never operate the snow thrower without proper guards, plates or other safety protective devices in place.

11.Never operate the snow thrower near glass

enclosures, automobiles, window wells,

drop-oils, and the like without properadjustment

of the snow discharge angle. Keep children and pets away.

12.Do not overload the machine capacity by attempting to clear snow at too fast a rate.

13o Never operate the snowthrower at high transport speeds on slippery surfaces. Look behind and use care when backing°

t4. Never direct discharge at bystanders or allow anyone in tront of the snow thrower.

15.Disengage power to the auger/impeller when snow thrower is transported or not in use.

16.Useonly attachments and accessories approved by the manufacturer of the snow thrower (such as tire chains, electric start kits, etc.).

17.Never operate the snow thrower without good visibility or light. Always be sure of your footing, and keep a firm hold on the handles. Walk; never rug.

CAUTION: STOP THE

ENGINE BEFORE

UNCLOGGING

%DISCHARGE CHUTE.Lj

,=

MAINTENANCE AND STORAGE

1.Check shear bolts and other bolts at frequent improper tightness to be sure the snow thrower is in safe working condition.

2.Never store the snow throwerwith fuel inthe fuel tank inside a building where ignition sources are present such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure.

3.Always refer to operator's manual instructions for important details if the snow thrower isto be stored for an extended period°

4.Maintain or replace safety and instruction labels, as necessary.

5o Run the snow thrower a few minutes after throwing snow to prevent freeze-up of the auger/ impelter_

WARNING ...................

This snow thrower is for use on sidewalks, driveways, and other ground level surfaces. CAUTION should be exercised while using on

steep sloping surfaces. DO NOT USE SNOW THROWER ON SURFACES ABOVE GROUND

LEVEL such as roofs of residences, garages, porches or other such structures or buildings,

..................,,,

i Hl,ll,ll,,,

I_ LOOK FOR THIS SYMBOL TO POINT OUT

! A IMPORTANT SAFETY PRECAUTIONS. IT

!,_ MEANS--ATTENTION!!! BECOMEALERT!!!

,..===., YOUR SAFETY IS INVOLVED.

i iiiii

Image 3 Contents
Manual Training PreparationOperation Unclogging Safety RulesMaintenance and Storage Engine BeforeMaintenance Agreement Customer ResponsibilitiesPlug Index Table of ContentsCarton Tools Required for AssemblyContents of Parts BAG AsseTo Remove Snow Thrower HOW to SET UP Your Snow ThrowerAssembly Crank AssemblyFIG, 4B To Checkjadjust Clutch Control Cables To Install Shifter Lever KnobOperation To Stop Your Snow Thrower HOW to USE Your Snow ThrowerOperation To Control Snow DischargeFill GAS 3EFORE Starting the EngineFill OIL USE Wheel Lockout PINWarm Start To Start EngineFrozen Starter CarburetorRemove do Notturn Ignition KEY Disconnect Spark Plug Wire OPE AtionSnow Throwing Tips After First USE Snow ThrowerCustomer Responsibilities EngineSpark Plug To Adjust Scraper BAR To Adjust Chute Crank AssemblyPLASTIC\ Adjust the Clutch Control Ables Adjust BeltsRaction Drive Belt Auger Drive Belt To Replace BeltsSide AdjustivieAway from Fire or Flame Iacaution Drain Gasoline OutdoorsService a Dadjust TS To Adjust CarburetorTo Replace Auger Shear Bolt To Adjust or Replace To AdjustTo Replace Other Thrower Indoors or in AN ENEngine Storage Service Lubrication ChartService Records Schedule Correction Trouble Shooting PointsPage Craftsman 22 Snow Thrower Handle Assembly Repair PartsRER Part Name REE Craftsman 22 Snow Thrower Chute Control ROD RepairpartsREE Part Name Auger Housing Repair PartsNO. Part no Part Name Discharge Chute Repair PartsRER Frame Components Repair PartsEngine Components Repair Parts Drive Components Repair Parts NO. Part NO. Part Name REE Wheel Assembly Repair PartsINO Part Name Gear BOX Repair Parts Part NameDecals Auger HousingREE NO. Part no Part Name Shift Yoke Repair PartsCraftsman 4-CYCLE Engine Model Number Craftsman 4-CYCL.E Engine Choke Rewind Starter noPage Part Number Part Description Owners Anual