Recoil Starter (Optional Instructions): With engine running, pull starter rope with a rapid, continuous full arm stroke three or four times. Pulling the starter rope will produce a loud clattering sound, which is not harmful to the engine or starter.
3.To stop engine, remove the ignition key. Do not turn key. Disconnect the spark plug wire from the spark plug to prevent accidental starting while equipment is unattended.
NOTE: Do not lose ignition key. Keep it in a safe place. Engine will not start without the ignition key.
4.Wipe all snow and moisture from the carburetor cover in the area of the control levers. Also, move control levers back and forth several times. Leave throttle control lever in the STOP or OFF position. Leave choke control in the FULL choke position.
TO ENGAGE DRIVE
1.With the engine running near top speed, move shift lever into one of the six FORWARD positions or two REVERSE positions. Select a speed appropriate for the snow conditions that exist. Use the slower speeds until you are familiar with the operation of the snow thrower.
2.Squeeze the traction drive clutch grip against the right handle and the snow thrower will move. Release it and the drive motion will stop.
NOTE: NEVER move shift lever without first releasing the drive clutch.
TO ENGAGE AUGERS
To engage the augers and start the snow throwing action, squeeze the auger clutch grip against the left handle. Release to stop the augers (traction drive clutch grip must also be released).
OPERATING TIPS
NOTE: Allow the engine to warm up for a few minutes as the engine will not develop full power until it reaches operating temperature.
WARNING: Temperature of muffler and surrounding areas may exceed 150oF. Avoid these areas.
1.For most efficient snow removal, remove snow immediately after it falls.
2.Discharge snow downwind whenever possible. Slightly overlap each previous swath.
3.Set the skid shoes 1/4" below the scraper bar for normal usage. The skid shoes may be adjusted upward for
4.Be certain to follow the precautions listed under ‘‘To Stop Engine’’ to prevent possible
5.Clean the snow thrower thoroughly after each use.
SECTION 8: ADJUSTMENTS
WARNING: NEVER attempt to clean chute or make any adjustments while engine is running.
CHUTE ASSEMBLY ADJUSTMENT
The distance snow is thrown can be adjusted by adjusting the angle of the chute assembly. Refer to the Control section of this manual.
SKID SHOE ADJUSTMENT
The space between the shave plate and the ground can be adjusted. Refer to the Final Adjustments section page 10.
TRACTION DRIVE CLUTCH
ADJUSTMENT
Refer to the Final Adjustment section of the Assembly Instructions to adjust the traction drive clutch. If you are uncertain that you have reached the correct adjustment, the adjustment can be physically checked as follows.
With the snow thrower tipped forward (be certain to drain the gasoline or place plastic film under the gas cap if the snow thrower has already been operated), remove the frame cover underneath the snow thrower by removing four
With the traction drive clutch released, there must be clearance between the friction wheel and the drive plate in all positions of the shift lever. With the traction drive clutch engaged, the friction wheel must contact the drive plate. See Figure 20.
If adjustment is necessary, loosen the lock nut on the traction drive cable and thread the cable in or out as necessary. Tighten the lock nut to secure the cable when correct adjustment is reached. Reassemble the frame cover.
NOTE: If you placed plastic under the gas cap, be certain to remove it.
13