ATTACHING THE TRACK CONTROLS
(Hardware F)
1.Remove the screw from the top of the right hand track control. Be careful not to lose the flat weld nut that is inside the control.
2.Place the right track control in position underneath the right handle. Secure with screw just removed. See Figure 12.
3.Secure the left track control in the same manner.
4.Attach track control cable to track control handle by inserting cable ball into slot on track control handle. Push cable down and up until it snaps into front of track control handle. Repeat on other side.
5.Secure the track control cables to the inside of the lower handle using the cable ties provided. Pull the cable ties tight, and trim the excess ends of the cable ties. See Figure 12
4.When correct adjustment is reached, tighten the hex jam nut against the bottom portion of the cable to lock it in position.
“Z” End
Hex Jam
Nut
Cable
is Straight
Figure 13
Screw
Right
Track
Control
Figure 12
ATTACHING THE CLUTCH CABLES
The “Z” end of the clutch cables are hooked into the clutch grips on each handle. Attach cables as follows.
1.Thread the hex jam nuts all the way up the threaded portion of the “Z” ends of the clutch cables.
2.Make certain each cable is in groove of cable roller guides. Place the clutch grip in the raised (up) position.
3.Thread the cable onto the threaded portion of the “Z” and until there is no slack in the cable, but the cable is NOT tight. Do not overtighten cable. See Figure 13.
WARNING: Overtightened of the cable will create a safety hazard by disallowing the clutch to disengage. Do NOT overtighten.
ATTACHING THE SHIFT ROD
(Hardware B)
1.Place the shift lever (on the handle panel) in the fifth speed position (all the way to the left).
2.Place the bent end of the shift rod into the hole in the shift arm assembly. See Figure 15. Secure with flat washer and hairpin clip.
3.Start threading the ferrule onto the other end of the shift rod. Lift up on the shift rod (and shift arm assembly) as far as it will go.
4.Thread the ferrule onto the shift rod until the ferrule lines up with the lower hole in the shift lever (beneath the handle panel). Insert the ferrule into the upper hole in the shift lever from the left side when adjustment is correct. Secure with flat washer and hairpin clip.
5.Make certain to check for correct adjustment of the shift rod as instructed in the Final Adjustment section before operating the snow thrower.
LAMP WIRING
Lamp Wire
Alternator
Lead
Right Handle
Figure 14
1.Wrap the wire from the lamp down the right handle until the wire can be plugged into the alternator lead wire under the fuel tank. See Figure 14. Be sure lamp wire does not interfere with the movement of any controls or cables.
9