Poulan 435999, 96198002702 owner manual Troubleshooting

Page 20

TROUBLESHOOTING

See appropriate section in manual unless directed to an authorized service center/department.

PROBLEM

 

CAUSE

 

CORRECTION

Does not start

1.

Fuel shut-off valve (if so

1.

Turn fuel shut-off valve to OPEN position.

 

 

equipped) in OFF position.

 

 

 

2.

Safety ignition key

2.

Insert safety ignition key.

 

 

is not inserted.

 

 

 

3.

Out of fuel.

3.

Fill fuel tank with fresh, clean gasoline.

 

4.

Throttle in STOP position

4.

Move throttle to FAST position

 

 

(or ON/OFF switch is OFF).

 

(or ON/OFF switch to ON position).

 

5.

Choke in OFF position.

5.

Move to FULL position.

 

6.

Primer not depressed.

6.

Prime as instructed in the Operation section of this manual.

 

7.

Engine is flooded.

7.

Wait a few minutes before restarting, DO NOT prime.

 

8.

Spark plug wire is

8.

Connect wire to spark plug.

 

 

disconnected.

 

 

 

9.

Bad spark plug.

9.

Replace spark plug.

 

10.

Stale fuel.

10.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

11.

Water in fuel.

11.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

 

 

 

 

Loss of power

1.

Spark plug wire loose.

1.

Reconnect spark plug wire.

 

2.

Throwing too much snow.

2.

Reduce speed and width of swath.

 

3.

Fuel tank cap is covered

3.

Remove ice and snow on and around fuel tank cap.

 

 

with ice or snow.

 

 

 

4.

Dirty or clogged muffler.

4.

Clean or replace muffler.

 

 

 

 

 

Engine idles or

1.

Choke is in FULL position.

1.

Move choke to OFF position.

runs roughly

2.

Blockage in fuel line.

2.

Clean fuel line.

 

3.

Stale fuel.

3.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

4.

Water in fuel.

4.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

5.

Carburetor is in need of

5.

Contact an authorized service center/department.

 

 

adjustment or overhaul.

 

 

 

 

 

 

 

Excessive

1.

Loose parts or damaged

1.

Tighten all fasteners. Replace damaged parts. If vibration

vibration

 

augers or impeller.

 

remains, contact an authorized service center/department.

 

 

 

 

 

Recoil starter

1.

Frozen recoil starter.

1.

See “IF RECOIL STARTER HAS FROZEN”

is hard to pull

 

 

 

in the Operation section of this manual.

 

 

 

 

 

Loss of traction

1.

Drive belt is worn.

1.

Check / replace drive belt.

drive / slowing

2.

Drive belt is off of pulley.

2.

Check / reinstall drive belt.

of drive speed

3.

Friction drive wheel is worn.

3.

Contact an authorized service center/department.

 

 

 

 

 

Loss of snow

1.

Auger belt is off of pulley.

1.

Check / reinstall auger belt.

discharge or

2.

Auger belt is worn.

2.

Check / replace auger belt.

slowing of

3.

Clogged discharge chute.

3.

Clean snow chute.

snow discharge

4.

Augers / impeller jammed.

4.

Remove debris or foreign object from augers / impeller.

 

 

 

 

 

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model Number Snow ThrowerSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Assembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerParts Packed Separately in Carton Remove Snow Thrower from CartonUnfold Upper Handle Install Speed Control ROD See FigsInstall Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Install Discharge Chute / Chute Rotator Head See FigInstall Chute Deflector Remote Control See Figs a and 8B Check Tire PressureOperation Know Your Snow ThrowerPrimer Ignition KEYMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineHOW to USE Your Snow Thrower StoppingTo USE Fuel SHUT-OFF Valve See Fig To USE Choke Control See FigUsing the CLEAN-OUT Tool See Fig Power Steering Operation See FigTo Throw Snow See Fig To Move Forward and Backward See FigTo Adjust Skid Plates See Fig Before Starting the EngineScraper BAR See Fig Check Engine OIL Level See FigSnow Throwing Tips To Start EngineBefore Stopping If Recoil Starter has FrozenMaintenance General RecommendationsBefore Each USE LubricationCleaning EngineService and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See FigTo Replace Belts See Fig To Adjust Cable Tension See Fig To Remove Wheels See FigCarburetor Engine SpeedStorage OtherFuel System Engine OILTroubleshooting Auger Housing Auger Assembly LHAuger Assembly RH KEY Part DescriptionExploded Gearbox Assembly 178675X431 Corner Bracket Clean OUT ToolBearing Impeller PulleyAuger Bearing Bearing PlugSkid Plate LH Skid Plate RHChute Snow Shield 419822X431 Shield Retainer Strap Knob BlackPOP Rivet LEVER/CABLE Rotator Assembly Cable Assembly AdjustableRotator Head Rotator Pivot Bracket196944X431 Panel Bracket LH 196943X431 Panel Bracket RH Handle GripWasher Lower HandleSpacer RetainerKnob RED Handle KnobImpeller ROD Traction RODShifter ROD TOP Shifter ROD BottomWire Harness Console PanelHeadlight Bezel Flood HeadlightAxle Shaft SprocketExploded Speed Selector Assembly Drive Plate AssemblyWheel HUB END PlateComplete LCT Engine Frame427963X428 Engine Mounting PlateImpeller Belt Traction BeltIdler ARM Bracket Idler PulleyWheel Assembly LH 432333X421432334X421 Cable Bracket LHCover Wheel Driver Retainer RingWheel Lobe Clutch SlideSafety Ignition KEY 422663DECAL, Danger DECAL, DANGER, DeflectorDECAL, Instruction DECAL, Speed ControlLimited Warranty

435999, 96198002702 specifications

The Poulan 96198002702,435999 is a high-performance chainsaw designed for both professional use and demanding residential applications. This powerful tool is engineered to deliver exceptional efficiency and reliability, making it a preferable choice for users seeking durability and cutting precision.

One of its main features is the robust engine. The Poulan chainsaw is equipped with a potent two-cycle engine that provides ample power for cutting through thick limbs and logs. The engine's design ensures quick start-up capabilities, which is crucial for maintaining productivity on the job site or during weekend projects.

The chainsaw incorporates a powerful 18-inch bar and chain, optimized for both speed and cutting efficiency. This length allows for a greater cutting capacity, making it suitable for a variety of tasks, from pruning small branches to felling larger trees. The chain itself is designed for optimal cutting performance, reducing kickback and ensuring smooth, clean cuts.

Another noteworthy characteristic is the chainsaw's lightweight construction. Weighing significantly less than many competitors in its class, the Poulan 96198002702,435999 is designed for easy handling. This feature reduces user fatigue during extended use, allowing for longer work periods without discomfort.

The chainsaw also boasts user-friendly technology. The automatic oiler ensures that the bar and chain remain lubricated during operation, thereby extending the life of the chain and providing consistent performance. The tool-free chain tensioning system allows users to quickly and easily adjust the chain to maintain optimal tension without the need for additional tools, ensuring safety and efficiency.

Additionally, the design of the Poulan chainsaw includes anti-vibration technology, which plays a crucial role in reducing user fatigue and increasing comfort. This feature lowers the amount of vibration transmitted to the user’s hands, enabling them to work longer without discomfort.

Safety is also a priority in the design of the Poulan 96198002702,435999. The chainsaw is equipped with features such as a chain brake to prevent accidental cuts and enhance user safety. Furthermore, the ergonomic handle provides a secure grip, allowing users to maintain control even in challenging conditions.

In summary, the Poulan 96198002702,435999 combines power, efficiency, and user-focused features to create a reliable chainsaw suitable for a broad range of applications. Whether for professional forestry work or home landscaping tasks, this chainsaw is designed to meet the demands of any cutting job while ensuring user safety and comfort.
Top Page Image Contents