MTD E740F manual Contents of Hardware Pack

SECTION 2: CONTENTS OF HARDWARE PACK

Lay out the hardware according to the illustration for identification purposes. Part numbers are shown in parentheses. (Hardware pack may contain extra items which are not used on your unit.)

A ATTACHING THE HANDLES				B ATTACHING THE CHUTE ASSEMBLY
				Hex Bolts
Hex Bolts				(710-3015)
				1/4-20 x 3/4”
5/16-18 x 1-3/4”
(710-3180)
	Hex Bolts
	5/16-18 x 3/4”		Handle Tabs
	(710-3008)		(784-5599)
		Lock Washers
		5/16” I.D.
		(736-0119)
Carriage Bolts
5/16-18 x 1-1/2”				Chute Flange	Hex Lock Nuts
(710-0262)
				Keepers	1/4-20 Thread
				(731-0851A)	(712-3027)
Cupped Washers				ATTACHING THE CHUTE DIRECTIONAL
5/16” I.D.
				C CONTROL ASSEMBLY
(736-0242)
Hex Nuts					Flat Washers
					3/8” I.D. x 5/8” O.D.
5/16” Thread					(736-0185)
(712-3010)
ATTACHING THE SHIFT ROD					Cupped Washers
D AND CLUTCH CABLES					5/16” I.D.
				Hair Pin Clip	(736-0242)
				(714-0104)
Ferrule	Flat Washers			Eyebolt Not Shown	Hex Nut
			Hair Pin Clip		5/16” Thread
(711-0677)	3/8” I.D. x 5/8” O.D.			(747-0697)	(712-3010)
			(714-0104)
	(736-0275)
E AUGER SHEAR BOLTS (SPARES)				F ATTACHING THE TRACK CONTROLS
	Shear Bolts	Hex Lock Nuts
	(710-0890A)
		5/16” Thread
		(712-0429)
				Track Control Triggers
				(746-0950)

NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and nuts are provided for your convenience. Store in a safe place until needed.

5