MTD E740F manual Shift Lever, Chute Directional Control, Skid Shoe, Throttle Control

Page 10

Traction Control /

Shift Lever

 

 

 

Auger Control Lock

 

 

 

 

 

 

 

 

Auger Drive

 

 

Discharge

Control

Closed

 

Track Steering

 

 

 

Chute

 

 

Control

 

Open

 

 

 

 

 

 

 

 

Electric

 

 

Primer

 

Starter

 

 

 

Button

 

 

 

 

 

Chute Directional

Choke

 

Switch

 

 

Box

 

Control

 

 

 

 

 

 

 

 

Safety

 

Recoil

Auger

 

Ignition Key

Starter

Skid Shoe

 

Throttle

Handle

 

 

 

 

 

 

Control

 

Figure 12

Shift Lever

The shift lever is located in the center of the handle panel and is used to determine both ground speed and direction of travel. It can be moved into any of eight positions. See Figure 12.

Forward

Your snow thrower has six forward (F) speeds. Position number one (1) is the slowest. Position number six (6) is the fastest.

Reverse

Your snow thrower has two reverse (R) speeds. R1 is the slower, while R2 is the faster of the two.

IMPORTANT: Always release tractional control before changing speeds.

Chute Directional Control

The chute directional control is located on left side of the snow thrower. See Figure 12.

To change the direction in which snow is thrown, turn chute directional control as follows:

Crank clockwise to discharge to the left.

Crank counterclockwise to discharge to the right.

NOTE: It is easier to maneuver a non-running snow thrower with both track steering controls held in simultaneously.

Headlight (If Equipped)

The headlight is on whenever the engine is running.

Skid Shoe

The position of the skid shoe is determined by the condition of the ground from where snow has to be removed. See Figure 12.

Throttle Control

The throttle control is located on the engine. It regulates the speed of the engine and will shut off the engine when pushed down completely. See Figure 12.

Safety Ignition Key

The safety ignition key must be fully inserted in the switch before the unit will start. Remove the ignition key when the snow thrower is not in use. See Figure 12.

IMPORTANT: Do NOT attempt to turn the key.

Track Steering Controls

The left and right track steering controls are located on the underside of the handles and are used to assist in steering the snow thrower. Squeeze the right track control when turning right and squeeze the left control when turning left. Operate your snow thrower in open areas until you become familiar with these controls. See Figure 12.

Fuel Shut-off Valve

The fuel shut-off valve, located under the fuel tank, controls fuel flow from the tank. Always make certain it is in the Open (vertical) position before attempting to start the engine. See Figure 12.

10

Image 10
Contents OPERATOR’S Manual Table of Contents Preparation Important Safe Operation PracticesTraining OperationMaintenance And Storage Your ResponsibilityContents of Hardware Pack Assembling Your Snow Thrower Attaching Handle AssemblyAttaching Chute Assembly UnpackingHardware C Attaching Shift RodUse Hardware D Attaching Control Cables Auger Control AdjustmentSkid Shoe Adjustment Attaching Track ControlsKnow Your Snow Thrower Traction Control and Shift Lever AdjustmentAuger Drive Control Chute Directional Control Safety Ignition KeyShift Lever Skid ShoeOperating Your Snow Thrower To Engage Track Drive Recoil StarterTo Stop Engine To Engage AugersChute Directional Control And Support Bracket Adjustment Auger Control AdjustmentTraction Control Adjustment Shift Rod AdjustmentMaintaining Your Snow Thrower Skid Shoe AdjustmentChute Assembly LubricationEngine Belt Removal And ReplacementServicing Your Snow Thrower AugersServicing Friction Wheel Rubber Drive BeltOff-season Storage Troubleshooting Problem Cause RemedyModel E740F Part DescriptionModel E740F Part Description Model E740F Part Description 315 Model E740F 4039 Model E740F Model E740F Model E740F Page Page MANUFACTURER’S Limited Warranty for