Poulan 96192004602 Cover, Wheel Driver, Wheel Lobe, Clutch Slide, Axle Lobe, Steering Yoke

Page 37

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PR8P27ES (96192004602)

WHEELS

																2
								17								3	2
							20	17			23				4	3	1
							20		19					6	5
							16		19				7	6	5
				17		18	16		22
							15		22			8
							15				9
				16			24				9
							24				10
											10
				20		23		21			11
				19			22
				19							12
				21							12
										13	14
							11	14	13	13
							11	14
					8	910		12
2				7	8
2				7
	3	4	5	6
	3	4
2	1		01.15.001-B
2			01.15.001-B
								KEY			PART		DESCRIPTION
								NO.			NO.		DESCRIPTION
								1			405161		COVER
								2			184471		SHOULDER SCREW
								3			12000045		RETAINER RING
								4			192126		WHEEL DRIVER
								5			182466		RETAINER RING
								6			187622		WHEEL LOBE
								7			194941		CLUTCH SLIDE
								8			179139		SPRING
								9			189282		SQUARE KEY
								10			194940		AXLE LOBE
								11			174697		THRUST WASHER
								12			193506X431		STEERING YOKE
								13			179148X431		STEERING BRACKET
								14			17490508		SCREW 5/16−18 X .50
								15			194943X008		PIVOT BRACKET
								16			194944X008		BELLCRANK
								17			181847		BELLCRANK PIN
								18			17600406		SCREW 1/4−20 X .375
								19			405077		STEERING LINK
								20			700279		RETAINER
								21			85179		RETAINER
								22			193885		SPRING
								23			182015		LEVER PIN
								24			194939X008		PIVOT BRACKET

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 37

Image 37

Contents Snow Thrower Model NumberSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents HOW to SET UP Your Snow Thrower Assembly / PRE-OPERATIONParts Packed Separately in Carton Remove Snow Thrower from CartonInstall Traction Drive Control ROD See Figs Install Speed Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotater Head See Fig Install Auger Control ROD See FigsCheck Tire Pressure Install Chute Deflector Remote Control See FigsKnow Your Snow Thrower OperationPrimer Ignition KEYRecoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety RequirementsStopping HOW to USE Your Snow ThrowerTo USE Choke Control See Fig To Control Snow Discharge See FigPower Steering Operation See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig To Move Forward and Backward See FigBefore Starting the Engine To Adjust Skid Plates See FigScraper BAR See Fig Check Engine OIL Level See FigTo Start Engine Snow Throwing TipsBefore Stopping If Recoil Starter has FrozenGeneral Recommendations MaintenanceBefore Each USE LubricationEngine CleaningTo Adjust Snow Thrower Height Service and AdjustmentsChute Deflector Shear Bolts See FigTo Replace Belts See Fig To Remove Wheels See Fig To Adjust Cable Tension See FigCarburetor Engine SpeedOther StorageFuel System Engine OILTroubleshooting Service Notes Exploded KEY Part Description Scraper BAR Auger HousingAuger Bearing Bearing PlugAuger 27 RH Auger 27 LHSkid Plate LH Skid Plate RHKnob Black Deflector SealPOP Rivet Chute Snow Shield 419822X431 Shield Retainer StrapKEY Part Loop Handle RH Loop Handle LH419797X431 Lower HandleRetainer SpacerKnob RED Handle KnobCarriage Bolt 5/16-18 X 155377 NUT 5/16-18 169675 Console Panel Wire HarnessHeadlight Bezel Flood HeadlightRepair Parts Snow Thrower - Model Number PR8P27ES Drive Drive Plate Assembly Speed Selector AssemblyWheel HUB END PlateSprocket Axle ShaftFrame ENGINE, B&S436146X421 Engine Mounting Plate428684 Wheel Driver CoverWheel Lobe Clutch SlideCable Bracket LH Wheel Assembly LHCable Bracket RH 193071 Safety Ignition KEYDECAL, Danger 181037DECAL, DANGER, Deflector Service Notes Service Notes Service Notes Limited Warranty