Poulan 96192004602, 438371 owner manual 193071, Safety Ignition KEY

Page 39

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PR8P27ES (96192004602)

BAG OF PARTS

3

2

01.14.003-B

4			KEY	PART	DESCRIPTION
	6		NO.	NO.	DESCRIPTION
5	6		1	198563	POWER CORD
5			1	198563	POWER CORD
7	8		2	169675	RETAINER PIN
7			3	180684X008	WRENCH
			3	180684X008	WRENCH
			4	184505	REMOTE SPRING
			5	179829	SHOULDER BOLT 1/4-20
		9 10	6	191730	LOCKNUT 1/4-20
		9 10	7	72250505	CARRIAGE BOLT 5/16-18 X 5/8
			8	751153	LOCKNUT 5/16-18
			9	73800600	LOCKNUT 3/8-16
			10	19131316	WASHER 3/8
			11	192090	SHEAR BOLT 1/4-20 X 1-13/16
			12	73800400	LOCKNUT 1/4-20
	1	12
		11

	KEY	PART	DESCRIPTION
1	NO.	NO.	DESCRIPTION
1	1	193071	SAFETY IGNITION KEY

01.14.007-A

13

4

1

4

2

2

01.14.012-A

KEY	PART	DESCRIPTION
NO.	NO.	DESCRIPTION

1180445 SHIFTER ROD TOP

2187716 SHIFTER ROD BOTTOM

372270505 CARRIAGE BOLT 5/16-18 X .75

4

155377

NUT 5/16-18

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

39

Image 39

Contents Snow Thrower Model NumberSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Parts Packed Separately in CartonInstall Speed Control ROD See Figs Install Traction Drive Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotater Head See Fig Install Auger Control ROD See FigsCheck Tire Pressure Install Chute Deflector Remote Control See FigsIgnition KEY OperationKnow Your Snow Thrower PrimerRecoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety RequirementsTo Control Snow Discharge See Fig HOW to USE Your Snow ThrowerStopping To USE Choke Control See FigTo Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Throw Snow See FigCheck Engine OIL Level See Fig To Adjust Skid Plates See FigBefore Starting the Engine Scraper BAR See FigIf Recoil Starter has Frozen Snow Throwing TipsTo Start Engine Before StoppingLubrication MaintenanceGeneral Recommendations Before Each USEEngine CleaningShear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute DeflectorTo Replace Belts See Fig Engine Speed To Adjust Cable Tension See FigTo Remove Wheels See Fig CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Service Notes Exploded KEY Part Description Bearing Plug Auger HousingScraper BAR Auger BearingSkid Plate RH Auger 27 LHAuger 27 RH Skid Plate LHChute Snow Shield 419822X431 Shield Retainer Strap Deflector SealKnob Black POP RivetKEY Part Lower Handle Loop Handle LHLoop Handle RH 419797X431Handle Knob SpacerRetainer Knob REDCarriage Bolt 5/16-18 X 155377 NUT 5/16-18 169675 Flood Headlight Wire HarnessConsole Panel Headlight BezelRepair Parts Snow Thrower - Model Number PR8P27ES Drive END Plate Speed Selector AssemblyDrive Plate Assembly Wheel HUBSprocket Axle ShaftEngine Mounting Plate ENGINE, B&SFrame 436146X421428684 Clutch Slide CoverWheel Driver Wheel LobeWheel Assembly LH Cable Bracket LHCable Bracket RH 193071 Safety Ignition KEY181037 DECAL, DangerDECAL, DANGER, Deflector Service Notes Service Notes Service Notes Limited Warranty