® | QUICK START |
NOTE: This section will describe navigation of the front panel controls as follows:
The button to press will be shown in ALL CAPITALS. For QUICK START, a number following in parentheses (#) will also be included. These refer to the same names and numbers as shown in Figure 1, Front Panel Controls and Indicators. The expected display text is shown in "quo- tation marks". If you press a button and the display does not change, it means that the but- ton has no effect for that particular menu item.
If you get to a certain point in the menu and want to go back, but cannot, press QUIT (5) and begin the steps again. This is normal for the unit.
1.Before hooking up the system, make sure that all items are OFF, especially the power amps.
2.Use high quality balanced XLR mic cables to make the connections. The feeds from the DS24/DS26 at "front of house" can also be sent through the audio snake returns to the amp stacks if used in a live setting.
3.You should know the frequency response and limits of your loudspeakers
4.Connect the main output or outputs of your mixer to the inputs of the DS24/DS26.
5.Depending on the configuration you select, connect the appropriate number of outputs from the DS24/DS26 to your power amp inputs.
6.Turn on the DS24/DS26.
7.After a brief start up, the display will show "2 x 2 WAY
8.Press MENU (3).
Press ENTER (6).
Press NEXT (2) "Design a Xover"
9.Press ENTER (6).
Select the crossover mode desired with either the BACK/NEXT (2) buttons or the Parameter dial. After selec- tion, Press ENTER (6).
4