MTD C Style warranty Two-Stage Snow Thrower C, D Style, MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio

Page 1

Safety • Assembly • Operation • Maintenance • Troubleshooting • Parts Lists • Warranty

OPERATOR’S MANUAL

Two-Stage Snow Thrower — C, D Style

IMPORTANT

READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION

Warning: This unit is equipped with an internal combustion engine and should not be used on or near any uniiproved forest-covered, brush- covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.

 

MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019

PRINTED IN U.S.A

FORM NO. 769-01274C

 

06/08/2005

Image 1
Contents MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio Two-Stage Snow Thrower C, D StyleForm no -01274C 06/08/2005Finding and Recording Model Number Table of ContentsCustomer Support Your Responsibility Chute clean-out tool is fastened to the topYour Responsibility Restrict the use TrainingPreparationOperation Maintenance & StorageDo not modify engine Your ResponsibilityPosition the chute assembly over the base Setting Up Your Snow ThrowerRemove the flat washer and hairpin clip from the end Tire PressureChute directional control Know Your Snow Thrower Operating Your Snow ThrowerChute Assembly Clean-Out ToolAuger Control Drive ControlStopping The Engine Gas & Oil Fill-UpIf your home’s Electric StarterTo Engage Drive Chute Clean-Out ToolTo Engage Augers Recoil StarterMaking Adjustments To adjust the skid shoes Chute Bracket AdjustmentRetightening the nuts Surrounding propertyEngine Maintaining Your Snow ThrowerLubrication Shave Plate and Skid ShoesAuger Belt Replacement Drive Belt Replacement Assembly off the shaft That it rests on the auger housingFriction Wheel Removal Cracking and replace if necessaryPreparing Engine Off-Season StoragePreparing Snow Thrower Problem Cause Remedy Trouble ShootingStyles C & D To order replacement Parts, contact Or visit Styles C & D Handle Ass’y, Lock, RH Handle Ass’y, Lock LH710-0376 710-0604AStyles C & D 684-04153 Disc, Friction Wheel684-04154 712-0413Page Page MANUFACTURER’S Limited Warranty for