OPERATION
SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
THROTTLE
/ENGINE
CONTROL
RECOIL | POWER |
|
CORD | ELECTRIC | |
(AUXILIARY) | PLUG | START |
STARTER |
| BUTTON |
HANDLE |
| |
|
| |
PRIMER |
|
|
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ENGINE OIL CAP | AUGER |
WITH DIPSTICK | CONTROL |
| LEVER |
GASOLINE
FILLER CAP
CHUTE DEFLECTOR
OIL
DRAIN
PLUG
DISCHARGE
CHUTE
FUEL CLEAN-
VALVE TOOL
FIG. 10
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED | DEFLECTOR REMOTE | |
CONTROL LEVER | ||
CONTROL LEVER | ||
TRACTION | ||
| ||
| DRIVE | |
| CONTROL | |
| LEVER |
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
DRIFT CUTTER
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Drift cutter - used to cut through deep snowdrifts.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
LH and RH turn triggers - used to steer the snow thrower.
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
Deflector remote control lever - used to change the
9 distance the snow is thrown.