MTD 611 manual OFF-SEASON Storage

Page 18

SECTION 11: OFF-SEASON STORAGE

WARNING: Never store engine with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or other gas appliance.

If unit is to be stored over 30 days, prepare for storage as follows:

1.Remove all gasoline from carburetor and fuel tank to prevent gum deposits from forming on these parts and causing possible malfunction of engine.

Run engine until fuel tank is empty and engine stops due to lack of fuel.

Drain carburetor by pressing upward on bowl drain, located below the carburetor cover.

WARNING: Drain fuel into approved container outdoors, away from open flame. Be certain engine is cool. Do not smoke. Fuel left in engine during warm weather deteriorates and will cause serious starting problems.

NOTE: Fuel stabilizer (such as STA-BIL) is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow it to reach carburetor. Do not drain carburetor if using fuel stabilizer.

Remove all dirt from exterior of engine and equipment.

Remove spark plug and pour one (1) ounce of engine oil through spark plug hole into cylinder. Crank engine several times to distribute oil. Replace spark plug.

Follow lubrication recommendations on page 15.

NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rust proof the equipment. Using a light oil or silicone, coat the equipment, especially any chains, springs, bearings and cables.

18

Image 18
Contents Important Read Safety Rules and Instructions Carefully MTD Products INC. P.O. BOX 368022 CLEVELAND, OhioPreparation Important Safe Operation PracticesTraining OperationMaintenance and Storage Finding Your Model Number Calling Customer SupportContents of Hardware Pack Unpacking Assembly InstructionsTools Required for Assembly Loose Parts in Carton See FigureAttaching the Handles Hardware a Attaching the Clutch GripsAttaching the Handle Panel Attaching Speed Selector Plate and Shift Lever Hardware DAttaching the Clutch Cables Attaching the Chute Assembly Hardware F Attaching the Chute Crank Hardware GAdjusting the Skid Shoes Final Assembly and AdjustmentsTraction Drive Clutch and Shift Lever Adjustment Auger Drive ClutchControls Electric Starter OperationBefore Starting GAS and OIL FILL-UPTo Engage Augers To Stop EngineTo Engage Drive Operating TipsAdjustments Maintenance LubricationBelt Removal and Replacement Auger Belts Drive Belt Changing the Friction Wheel RubberOFF-SEASON Storage Trouble Shooting Guide Model Part Description QTY Model Wheel Assembly Part Description QTY 736-0331 Page Page MANUFACTURER’S Limited Warranty for