SECTION 5: ASSEMBLY INSTRUCTIONS
IMPORTANT: After assembly, service engine with gasoline, and check oil level as instructed in the separate engine manual packed with your unit.
NOTE: References to right or left side of the snow thrower are determined from behind the unit in the operating position.
UNPACKING
•Remove staples or break glue on the top flaps of the carton. Remove any loose parts included with unit (i.e., owner’s manual, etc.).
•Cut along dotted lines and lay end of carton down flat. Remove packing material.
•Roll unit out of carton. Check carton thoroughly for loose parts before discarding.
A
G
TOOLS REQUIRED FOR ASSEMBLY
•(1) 3/8" or adjustable wrench
•(2) 7/16" or adjustable wrench
•(2) 1/2" or adjustable wrench
LOOSE PARTS IN CARTON (See Figure 3)
A(2) Handles (Right and Left)
B(1) Pivot Rod
C(1) Cover Tube
D(2) Clutch Grips (Right and Left)
E(1) Handle Panel
F(1) Speed Selector Plate
G(1) Shift Lever
H(1) Chute Crank Assembly
J | (1) | Chute Assembly |
I | (1) | Hardware Pack |
D
B
C
E
H
F
J
Figure 3
6