Simplicity 11532, 9560, 9524, 1380, 11570, 1338, 10528, 10560 manual SafetyRules& Information

Page 3

SafetyRules& Information

follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury

_ his machine is capable to amputating hands and feet and throwing objects. Read these safety rules and or death to you, or bystanders, or damage to property or equipment. The triangle ,_ in text signifies

important cautions or warnings which must be followed.

TRAINING

1.Read, understand, and follow all instructions on the machine and in the manuals before operating this unit. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

2.Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

3.Keep the area of operation clear of all persons, partic- ularly small children and pets.

4.Exercise caution to avoid slipping or falling especially when operating in reverse.

PREPARATION

1.Thoroughly inspect the area where the equipment is to be used and remove all doormat, sleds, boards, wires, and other foreign objects.

2.Disengage all clutches and shift into neutral before starting engine (motor).

3.Do not operate the equipment without wearing ade- quate winter outer garments. Wear footwear that will improve footing on slippery surfaces. Avoid loose fit- ting clothing that can get caught in moving parts.

4.Handle fuel with care; it is highly flammable.

(a)Use an approved fuel container.

(b)Never add fuel to a running engine or hot engine.

(c)Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors. Replace fuel cap securely and wipe up spilled fuel.

(d)Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place con- tainers on the ground, away from your vehicle, before filling.

(e)When practical, remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such on a trailer with a portable container, rather than from a gasoline dis- penser nozzle.

(f)Keep nozzle in contact with the rim of the fuel tank or container opening at all times, until refueling is complete. Do not use a nozzle lock-open device.

(g)Replace gasoline cap securely and wipe up spilled fuel.

(h)If fuel is spilled on clothing, change clothing imme- diately.

5.Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors or electric starting motors.

6.Adjust the collector housing height to clear gravel or crushed rock surfaces.

7.Never attempt to make any adjustments while the engine (motor) is running (except when specifically recommended by the manufacturer).

8.Let engine (motor) and machine adjust to outdoor temperatures before starting to clear snow.

9.Always wear safety glasses or eye shields during operation or while performing an adjustment or repair to protect eye from foreign objects that may be

thrown from the machine. TP-600-3606-03-LW-UV

OPERATION

1.Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times.

2.Exercise extreme caution when operating on or

crossing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic.

3.After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, disconnect the cord on electric motors, thoroughly inspect the snowthrower for any damage, and repair the damage before restarting and operating the snowthrower.

4.If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

5.Stop the engine (motor) whenever you leave the operating position, before unclogging the collector/impeller housing or discharge guide, and when making any repairs, adjustments, or inspec- tions.

6.When cleaning, repairing, or inspecting make certain the collector/impeller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the plug to prevent accidental starting.

7.Do not run the engine indoors except for starting the engine or for transporting the snowthrower in or out of the building. Open the outside doors; exhaust fumes are dangerous.

8.Exercise extreme caution when operating on slopes. Do not attempt to clear steep slopes.

9.Never operate the snowthrower without proper guards plates, or other safety protective devices in place and working.

10.Never direct the discharge toward people or areas where property damage can occur. Keep children and others away.

11.Do not overload the machine capacity by attempting to clear snow at too fast a rate.

12.Never operate the machine at high transport speeds on slippery surfaces. Look behind and use care when operating in reverse.

13.Disengage power to the collector/impeller when snowthrower is transported or not in use.

14.Use only attachments and accessories approved by the manufacturer of the snowthrower (such as wheel weights, counterweights, or cabs).

15.Never operate the snowthrower without good visibility or light. Always be sure of your footing, and keep a firm hold on the handles. Walk, never run.

16.Never touch a hot engine or muffler.

17.Never operate the snowthrower near glass enclo- sures, automobiles, window wells, drop-offs, and the like without proper adjustment of the discharge angle.

18.Never direct discharge at bystanders or allow anyone in front of the unit.

19.Never leave a running unit unattended. Always disen- gage the auger and traction controls, stop engine, and remove keys.

20.Do not operate the unit while under the influence of alcohol or drugs.

Image 3
Contents 10560 Models 1390 9524 Models 115709560 Models 1338 10528 Models 1380Tableof Contents SafetyRules& Information Children Safety RulesPage Decals North American Model DecalsCE Model Decals Safety Icons Safety iconsCE Models Only Identification NumbersCE Identification TAG Markings North American CE ModelsControl Locations Speed SelectorTraction Control / Free Hand TM Lock Easy Turn TM Control Auger ControlChute Direction Control Remote/Regular Deflector ControlChecks Before Each START-UP OperationManual Start Starting the EngineClearing a Clogged Discharge Chute Operating the SnowthrowerDeflector Full Traction Easy Turn TM Freewheeling Traction Drive LockEasy Turn TM Traction Storage After Each USEStorage SizePSIbar Maintenance ScheduleChecking Tire Pressure Auger Gear Case LubricationLubrication Regular MaintenanceRegularMaintenance Lubricating the Auger Shaft AssemblyCheck / Lubricate FREE-HAND Linkage Page Troubleshooting Troubleshooting,Adjustments,ServiceProblem TroubleshootingAuger Drive Tension Speed Selector AdjustmentInitial Adjustment Run-In AdjustmentTraction Drive Tension Manual Discharge Chute Control Linkage Adjustment Pinion Gear AdjustmentGear Bracket Adjustment Shear PIN Replacement Easy Turn TM Cable AdjustmentBelt Cover Screws Belt ReplacementTion Drive Tension ServiceDimensions EngineChassis Maintenance Items Replacement PartsPage Bimplicilq Operators Tableof Contents SafetyRules& Information Safety Rules Page Decals Safety icons IdentificationNumbers Features,Controls,& Operation Features & Controls General Operation Starting the Engine Operating the Snowthrower Deflector Full Traction Storage RegularMaintenance Regular Maintenance RegularMaintenance Page Troubleshooting,Adjustments,Service Troubleshooting Adjustments Traction Drive Tension Manual Discharge Chute Control Linkage Adjustment Adjustments & Service Belt Replacement Service Specifications Parts & Accessories Page Bimplicilq