Simplicity 9560, 9524, 1380, 11532, 11570, 1338, 10528, 10560 manual Traction Drive Tension

TRACTION DRIVE TENSION

Initial Adjustment

1.With the drive lever released there should be no slack in the cable when moved slightly from side to side, but bellcrank arm remains in fully down position.

1.To adjust tension on the cable loosen adjustment hex nut (D, Figure 19) by holding the adjusting flats (A). Turn the adjustment screw. The adjustment screw is a phillips screw and the head can be held or turned by inserting a screwdriver through the traction drive clutch cable spring

3.Engage the drive lever to check the adjustment. When correct, tighten hex nut securely. The unit should able to be pushed forward and back freely.

WARNING

Do not over-tighten, as this may cause traction drive to engage without depressing the traction drive control (bellcrank arm must remain in down position).

Verify that the cables are not over-tightened: With speed selector in position 1 and traction drive control fully released, push snowthrower forward.

The unit should move forward freely.

If unit does not move forward freely, the cable has been over-tightened. To remedy, loosen tension on clutch cable slightly, and recheck.

Run-In Adjustment

ALL MODELS

,After 5 hours of use, check for proper adjustment.

Readjust clutch cable if necessary by increasing ten- sion on cable. A small amount of bellcrank arm

movement is permissible if unit passes operating checks described in the Caution above.

Adjustments

O

Figure 19. Traction Drive Adjustment

A. Adjusting Flats

B. Spring Hook

C. Bellcrank Arm

D.Nut

E.Adjustment Screw

23