MTD 179cc, 208cc manual MANUFACTURER’S Warranty Coverage

Page 11

MTD LLC (MTD), The United States Environment Protection Agency (U. S. EPA)

Emission Control System Warranty Statement

(Owner’s Defect Warranty Rights and Obligations)

The U. S. EPA and MTD are pleased to explain the emissions control system warranty on your model year 2005 and later small off-road engine. New small off-road engines must be designed, built and equipped to meet the stringent anti-smog standards. MTD must warranty the emission control system on your engine for the period of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off-road engine.

Your emission control system may include parts such as the carburetor, air cleaner, ignition system, exhaust system, and other associated emis- sion-related components.

Where a warrantable condition exists, MTD will repair your small off-road engine at no cost to your including diagnosis, parts and labor.

MANUFACTURER’S WARRANTY COVERAGE:

This emissions control system is warranted for two years. If any emission-related part on your engine is defective, the part will be repaired or replaced by MTD.

OWNER’S WARRANTY RESPONSIBILITIES:

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your Owner’s Manual. MTD recommends that you retain all your receipts covering maintenances on your small off-road engine, but MTD can not deny warranty solely for the lack of receipts or for your failure to ensure the performance to all scheduled maintenance.

As the small off-road engine owner, you should however be aware that MTD may deny your warranty coverage if your small off-road engine or part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off-road engine to an Authorized MTD Service Dealer as soon as a problem exists. The warranted repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact a MTD Service Representative at 1-800-668-1238 and address is MTD Products Ltd., P. O,. Box 1386, 97 Kent Avenue, Kitchener, Ontario Canada N2 G 4J1.

Defects Warranty Requirements for 1995 and Later Small Off-Road Engines:

This section applies to 1995 and later small off-road engines. The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser.

(a)General Emissions Warranty Coverage

MTD must warrant to the ultimate purchaser and each subsequent purchaser that the engine is:

(1)Designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board pursuant to its authority in Chapters 1 and 2,Part 5, Division 26 of the Health and Safety Code; and

(2)Free from defects in materials and workmanship that cause the failure of a warranted part to be identical in all material respects to the part as described in the engine manufacturer’s application for certification for a period of two years.

(b)The warranty on emissions-related parts will be interpreted as follows:

(1)Any warranted part that is not scheduled for replacement as required maintenance in the written instructions required by Subsection (c) must be warranted for the warranty period defined in Subsection (a)(2). If any such part fails during the period of warranty coverage, it must be repaired or replaced by MTD according to Subsection (4) below. Any such part repaired or replaced under the warranty must be warranted for the remaining warranty period.

(2)Any warranted part that is scheduled only for regular inspection in the written instructions required by Subsection (c) must be warranted for the warranty period defined in Subsection (a)(2). A statement in such written instructions to the effect of “repair or replace as necessary” will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty must be warranted for the remaining warranty period.

(3)Any warranted part that which is scheduled for replacement as required maintenance in the written instructions required by Subsection (c) must be warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part must be repaired or replaced by MTD according to Subsection (4) below. Any such part repaired or replaced under warranty must be warranted for the remainder of the period prior to the first scheduled replacement point for the part.

(4)Repair or replacement of any warranted part under the warranty provisions of this article must be performed at no charge to the owner at a warranty station.

(5)Notwithstanding the provisions of Subsection (4) above, warranty services or repairs must be provided at all MTD distribution centers that are franchised to service the subject engines.

(6)The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact defective, provided that such diagnostic work is performed at a warranty station.

11

EPA-1-CA

Page 10 Page 12
Image 11
Page 10 Page 12
Contents 11/2007 Safety Operation Maintenance Storage Troubleshooting179cc and 208cc Horizontal Shaft OHV Snow Engines 769-03333Customer Support Table of ContentsEngine Components Operating EngineFuel Recommendations Pre-Operation CheckOil Recommendations Checking Oil LevelEngines with Electric Starters Inserted into ignition switchStarting the Engine Wipe any moisture away from the controls on the engine Stopping the EngineEngines with Starter Handle non-electric start Engine off after use and remove ignition keyOil Change Maintenance ScheduleOil Service MaintainingMaintaining Engine Spark Plug ServiceCleaning the Engine Spark Plug Spark Plug BootRemoving From Storage StorageElectrode gap set incorrectly Spark plug Stale fuel TroubleshootingProblem Cause Solution Engine runs erratically Spark plug wire looseMANUFACTURER’S Warranty Coverage EPA-1 Air à Filtre BougiesPropriétaire DU Responsabilités 11 CA-1-EPAPas Solution Cause ProblèmePannes des Détection Pannes des Détection’eau Net Ne RemisageToucher le EntretienMoteur du Nettoyage Jet un avec moteurIMPORTANTle pas nettoyez NeFacilement plus coule l’huile ’huile de Vidange’entretien opérations des Calendrier ’huile de VidangeLaissez ne surveillée, non utilisation Moteur du ArrêtMoteur le sur Quand surveillance sans moteur le jamaisBurant Moteur Du marche en MiseÉlectrique démarreur ’un équipés MoteursBougies Carburant le Concernant RecommandationsInitiale Vérification ’huile niveau du Vérification’huile Capuchon/jauge Moteur du PiècesDépart de Volet ObturateurMoteur du Utilisation Matières des TableUtiles renseignements des fournit Elle Remarque Moteur du Entretien03333-769

179cc, 208cc specifications

MTD, a renowned name in outdoor power equipment, has made significant strides in the world of garden machinery with its 208cc and 179cc engines. These robust engines are designed to meet the varying needs of homeowners and professional landscapers alike, ensuring reliability and performance in both residential and commercial settings.

The MTD 208cc engine stands out with its powerful output, making it an excellent choice for larger mowing tasks and tougher terrain. This engine provides ample torque, allowing for efficient cutting through thick grass and uneven ground. It features a recoil start for quick and easy ignition, accompanied by a built-in primer bulb that ensures reliable starting under various conditions. With a lightweight design, the 208cc engine promotes maneuverability without compromising on power, making it ideal for riders and walk-behind mowers.

In contrast, the MTD 179cc engine is slightly smaller yet equally capable. Its compact design offers a great balance between power and fuel efficiency, making it suitable for smaller lawns and garden projects. The 179cc engine is particularly favored for its user-friendly nature, designed for easy handling and operation, which appeals to homeowners who may not have extensive gardening experience. Like the 208cc model, it also features a recoil start and primer bulb for convenience.

Both engines utilize advanced technologies such as a low-oil shutdown feature, which protects the engine from potential damage by turning it off if oil levels drop too low. This is coupled with an efficient air filtration system that ensures the engine runs smoothly and reduces the frequency of maintenance. These features not only enhance the longevity of the engines but also promote sustainable usage by minimizing emissions and fuel consumption.

The construction of both engines reflects MTD’s commitment to durability and performance. They are built with high-quality materials that withstand the rigors of outdoor use. Additionally, these engines are designed with vibration-dampening features to provide operators with a more comfortable experience while in use.

In summary, MTD's 208cc and 179cc engines combine power, efficiency, and reliability, making them popular choices for a variety of lawn and garden applications. With user-friendly features and robust construction, these engines exemplify MTD's dedication to crafting innovative outdoor solutions tailored to meet diverse customer needs. Whether tackling a sprawling yard or maintaining a small garden, MTD provides the right engine to get the job done effectively.
Top Page Image Contents