Ground Speed Controls, Auger Control, Scraper Height

GROUND SPEED CONTROLS

A.Speed Selector - This lever (A, Figures 3 & 4) is used to set the ground speed of the snowthrower.

The snowthrower has five forward speeds, 1–5, and two reverse speeds, 1–2. No neutral position or gate is required, since the traction drive design automati- cally provides "neutral" (no forward or reverse move- ment), whenever the drive control is released.

B.Traction & Free Hand™ Control - This control engages the traction drive as the lever (B, Figures 3 & 4) is depressed, and disengages the traction drive when the lever is released. When both levers are depressed the Free Hand™ control is activated. This allows the auger control to be released yet the auger remains engaged until the traction Free Hand™ is released. NOTE: Changing ground speeds must only be done while the drive control is in the disengaged (fully released) position.

AUGER CONTROL

C.Auger Control - The auger control clutch lever (C Figures 3 & 4), engages the auger drive when the lever is depressed and disengages the auger drive when the lever is released (unless Traction Free Hand™ control is also depressed-see above).

DEFLECTOR CONTROLS

D.Chute Direction Control - The chute direction con- trol (D, Figures 3 & 4), allows the discharge chute to be rotated to throw snow in the desired direction.

Snow may be thrown at any angle from straight left, to straight forward, to straight right.

E.Chute Deflector - Controls the distance snow is thrown. Tilting the chute deflector (E, Figure 4) UP provides a higher stream and greater distance, while tilting the deflector DOWN provides a lower stream and less distance.

F.Chute Deflector Knob - This knob (F, Figure 4) allows the discharge chute deflector (E) to be locked in the desired tilt position.

SCRAPER HEIGHT

G, H. Scraper Bar Height Control - The skid shoes (G, Figure 4) control the height of the scraper bar (H). (NOTE: On later models, the scraper bar is also adjustable.) The scraper bar allows smooth surfaces (such as concrete or asphalt driveways) to be scraped clean of snow. On surfaces such as gravel, the scraper bar should be adjusted higher — so that it will not pick up gravel or debris.

			Controls
C	A	D	B

Figure 3. Operator's Control Position

A.	Speed Selector	C.Auger Control
B.	Drive Control	D.Chute Direction Control

A	D
	B
C
	E
I	F
I
G	H
	H

Figure 4. Snowthrower Controls

A. Speed Selector	E. Chute Deflector
B. Drive Control	F. Chute Deflector Knob
C. Auger Control	G. Skid Shoes
D. Chute Control Knob	H. Scraper Bar
	I. Traction Lock Pins

TRACTION LOCK CONTROL

I.Traction Lock Pins - The traction drive to each wheel can be locked and unlocked with the traction lock pins (I, Figure 4) to permit the unit to “free- wheel,” allowing easier manual handling and transport of the snowthrower.