DRIVE BELT ADJUSTMENT (Continued)
If the auger drive slips (auger slows or doesn't rotate nor- mally while blowing snow), or stays engaged when the control is disengaged — and the auger clutch cable has been properly adjusted — the auger drive belt may be out of adjustment.
WARNING
Auger must NOT rotate unless the Auger Control lever has been depressed. Proper Auger Drive Belt adjustments stop the auger within 5 seconds after the Auger Control is disengaged.
Checking Auger Belt & Belt Guide Adjustments
1.Insert the engine key and start the snowthrower.
2.Engage and disengage the auger control a series of ten times, checking that the auger comes to a com- plete stop within 5 seconds after the control is disen- gaged each time.
3.If the auger comes to a complete stop each time with- in 5 seconds, the adjustment is correct. If the auger does NOT come to a complete stop within the neces- sary 5 seconds, the adjustment is incorrect: readjust- ing the auger belt & belt guide according to the pro- cedures below.
Adjusting Auger Drive Belt
1.Make certain that the snowthrower is off, the engine key has been removed, and the spark plug discon- nected.
2.Check that there is no slack in the auger drive clutch cable (see Figure 26). If there is, follow the auger drive clutch cable Adjustment procedure on page 24.
3.Measure the length of the auger drive clutch spring (Figure 26).
4.Fully depress the auger control and measure the expanded length of the spring.
The spring should expand
5.Loosen the belt cover screws and remove the belt cover (Figure 25)
6.Loosen the adjustment bolt (see Figure 27) and move the auger idler pulley.
7.Tighten the adjustment bolt and repeat steps
8.Test run the unit. The auger must NOT rotate unless the auger control lever has been depressed. Proper auger drive belt adjustments stop the auger within 5 seconds after the auger control is disengaged. If the auger drive fails either of these tests, repeat the
Adjustments |
Auger Control |
Belt Cover |
Figure 25. Auger Control and Belt Cover Location
Auger Drive
Clutch Cable
Adjustment 
Hex Nut
Measure Spring Length, Spring 
Should Expand 5/16” When Auger is Engaged
Idler Rod | Right Handle |
Figure 26. Auger Drive Clutch Cable
Auger Idler |
| |
Pulley |
| |
Auger Idler |
| |
Arm |
| |
Adjustment | Auger | |
Bolt | ||
Drive Belt | ||
|
Figure 27. Auger Drive Belt, Guide and Pulley
adjustment procedures.
9.After adjusting the auger drive belt, the auger belt guide MUST BE adjusted according to the Adjusting Auger Belt Guide procedure which follows.
25