PARTS PACKED SEPARATELY IN CARTON
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety | 2. | Cut down all four corners of carton and lay panels flat. | |
before you attempt to assemble or operate your new | 3. | Remove the two (2) screws securing the auger housing | |
snow thrower. Reading the entire manual will familiar- | |||
| to the pallet. | ||
ize you with the unit, which will assist you in assembly, |
| ||
4. | Remove all packing materials except plastic tie holding | ||
operation and maintenance of the product. | |||
| speed control rod to lower handle. | ||
Your new snow thrower has been assembled at the factory |
| ||
5. | Remove the two (2) plastic ties securing the upper | ||
with the exception of those parts left unassembled for ship- | |||
| handle to the pallet. | ||
ping purposes. All parts such as nuts, washers, bolts, etc., |
| ||
6. | Remove snow thrower from carton and check carton | ||
necessary to complete the assembly have been placed in | |||
the parts bag. To ensure safe and proper operation of your |
| thoroughly for additional loose parts. | |
snow thrower, all parts and hardware you assemble must | HOW TO SET UP YOUR SNOW THROWER | ||
be tightened securely. Use the correct tools as necessary | |||
to ensure proper tightness. | TOOL BOX (See Fig. 8) | ||
| |||
REMOVE SNOW THROWER FROM CARTON | A toolbox is provided on your snow thrower. The toolbox is | ||
1. Remove all accessible loose parts and parts boxes | located on top of the belt cover. Store the extra shear bolts, | ||
4 nuts and | |||
from carton. |