Section 3 - MAINTENANCE
3.1INTRODUCTION
To retain the quality of the snow thrower, use genuine SNAPPER replacement parts only. Contact a local SNAPPER dealer for parts and service assistance. For the correct part or information for a particular snow thrower, always mention model and serial number.
3.2SERVICE - AFTER FIRST 5 HOURS
3.2.1 CHECK AUGER DRIVE BELT
1.Visually check engine drive belt for cracking, fraying, severed or belt strands exposed. Replace belt before operating snow thrower. See Figure 3.1
CHECK
AUGER DRIVE
BELT
FIGURE 3.1
3.2.2 CHECK AUGER FLITE SHOE
1.Visually check flite shoes for cracking, fraying, severed or belt strands exposed. Replace flite shoes before operating snow thrower.
CHECK AUGER
FLITE SHOE
FIGURE 3.2
10
3.2.3CHECK AUGER CLUTCH CONTROL CABLE 1. Visually check cable for fraying, kinking or severed cable strands. Replace cable and adjust tension before operating snow thrower.
CHECK AUGER
CONTROL
CABLE
FIGURE 3.3
3.3 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in the maintenance schedule.
3.3.1. Engine
Refer to engine owner’s manual for service instructions.
3.3.2. Spark Plug
Refer to engine owner’s manual for service instructions.
3.4 STORAGE PROCEDURE
Refer to the Engine Owner’s Manual for directions regarding engine storage preparations. Prepare the snow thrower for “end of season” storage as follows:
1.Drain fuel from fuel tank and let engine run until all fuel is out of the carburetor.
2.Disconnect and remove the spark plug wire away from spark plug before any other preparations are made!
3.Tape all openings closed to prevent spraying water into exhaust or air intakes during washing.
4.Tilt snow thrower up on its wheels and thoroughly clean the underside of the auger.
5.Lubricate all exposed metal with a light coating of oil to prevent corrosion.
6.Store the machine in a shed or other dry area, protected from weather.