Guardian Technologies H3010 Maintenance, Storage, Troubleshooting Guide, Problem, Solution

H3010REV0608 NO LEAD:Digital Humidifier Manual 2L 6/16/08 1:25 PM Page 5

MAINTENANCE

·Always unplug the unit before servicing it in any way.

·The water temperature of the water remaining in the unit after use may be high.

·Do not submerse the unit in water, or allow water to enter the inside of the unit.

INSIDE THE BODY OF THE UNIT

Pour excess water out of the unit, but do not allow it to enter the blast port. Wash out the unit with fresh water, using the cleaning brush and a soft cloth as needed.

OUTER SURFACE OF THE UNIT

Wipe the surface of the unit with a soft damp cloth if needed.

WATER TANK

If water spots remain in the water tank, wipe the inside with a soft cloth. Do not use soap or detergents.

AIR FILTER

Gently wipe away debris from the filter with a soft cloth.

ULTRASONIC DISK

Remove spray spout (Fig. 1) and use the enclosed cleaning brush to regularly remove build up and deposits from this area (Fig. 2). White vinegar will help to prevent this build up.

Fig. 1 Fig. 2

STORAGE

·Fully dry the inside and outside of the unit before storing it.

·DO NOT leave water in the unit.

·Store in a cool dry place.

TROUBLESHOOTING GUIDE

PROBLEM	SOLUTION
Water vapor & humidity are not	Power Plug: Unplug and then try again.
produced.	Power Failure: When the power is returned, try again.
	Tank Installation: Make sure the tank is correctly
	attached.
Air blows but water vapor is not	Excessive Water: Remove a certain amount of water from
produced.	the tank.
	The desired humidity is lower than the current
	temperature: increase the desired humidity.
	Detergent residue in the tank: Wash the tank out
	and try again.
Humidity level is low.	The surface of the ultrasonic metal circle may be dirty:
	Wipe it off with a dry soft cloth.
	The water in the unit is too cold: Replace with cool, but
	not cold water.
	Damage on the ultrasonic metal circle. Contact customer
	service 1-866-603-5900.
Warm humidity is not produced.	It may take 10-15 min. before warm humidity is created.
	The steam may not feel warm to the touch.
The humidity has a bad smell.	Poor maintenance or dirty water: Clean the product
	thoroughly, and fill it with fresh water.
White dust is forming on nearby	Hard water will deposit a certain amount of dust. Dust in
furniture.	the air settles because of the added humidity in the room.
	Use distilled water if this becomes a nuisance.
My current humidity will not go	The unit will not display a humidity setting below 25%.
below 25%.	This means the current humidity in your room is at or
	below 25%.

E-8 E-9