Simplicity 1691900, 1692469 Safety Signs & Decals, Safety Decals, Discharge Chute Danger Decal

Page 10

Safety Signs & Decals

SAFETY DECALS

Safety warning decals are placed at strategic locations on the snowthrower as a constant reminder to the opera- tor of the most important safety precautions. All warning, caution and instructional messages on your snowthrow- er should be carefully read and obeyed. If any of these decals are lost or damaged, replace them at once. They can be purchased from your local dealer.

Traction &

 

Free-Hand™

Discharge

Control

Control

2

1

3

4

 

 

 

WARNING

TO AVOID SERIOUS INJURY

Read Owner's Manual before operating unit.

Never allow children to operate snowthrower.

Always direct discharge chute so as to avoid injury to persons —or damage to property.

Stop engine and disconnect spark plug wire before removing debris or servicing unit.

Keep all shields and guards in place while running.

When BOTH levers are depressed, Free-Hand™ Control is activated. This allows Auger Engage Control to be released—yet auger rotation will continue until Free-Hand™ Control is released.

Auger Engage

Control

2

1

3

 

4

1716543

Part No. 1716543

WARNING / Main Dash Decal

DANGER

AVOID INJURY

FROM ROTATING

BLOWER!

Shut off engine before unclogging discharge chute.

1716533

Part No. 1716533

Discharge Chute Danger Decal

DANGER

AVOID INJURY

FROM ROTATING

AUGER!

Keep hands, feet, and clothing away.

1716532

Part No. 1716532

Auger Danger Decal

The decals below are supplied by the engine manufacturer. See your local Tecumseh dealer.

Engine "Hot" Decal

Engine

Instruction Decal

Engine Main

Operation Decal

03

4

Image 10
Contents How to use this file...Operators Manuals Print Vendors Paper ManualsThis page Intentionally Blank OPERATOR’S Manual Page 24E Models 500 N. Spring Street, P.O. Box 997 Port Washington, WI Table Of Contents General Safety RulesPreparation Maintenance & Storage OperationDischarge Chute Danger Decal Safety Signs & DecalsSafety Decals Auger Danger DecalSnowthrower Controls ControlsEngine Controls Starting Controls Electric Start Units OnlyDeflector Controls Ground Speed ControlsAuger Engage Control Scraper Height ControlOperation Checks Before Each START-UPWill Continue until the Free-Hand Control is released Starting the EngineOperating the Snowthrower Operators PositionDeflector Engine SpeedGround Speed Selector Scraper BAR & Skid ShoesAfter Each USE FREE-WHEELING Traction Drive LockKlik-Pin Outer Hole OFF-SEASON Storage Regular MaintenanceNormal Care Starting After StorageLubricate Point Where Control Rods Pass Through Bracket LubricationEngine fails to start ServiceTroubleshooting Engine starts hard or runs poorlyAuger rotates, but snow is not Scraper bar does not clean hardAuger does not stop when auger Thrown far enoughAuger Drive Tension Speed Selector AdjustmentBelt Replacement Traction Drive TensionMaintenance & Service Engine PulleyKeeper link Roller Chain ReplacementShear PIN Replacement Master link Direction of travelChecking Tire Pressure Discharge Control AdjustmentMounting Screws Specifications Accessories Common Replacement PartsTechnical Manual Availability