Service
DISCHARGE CONTROL
ADJUSTMENT
If the discharge chute is difficult to operate, first lubricate the pinion gear (A, Figure 27) and ring gear (F, Figure
27). If it is still difficult to operate, adjust as follows:
1.Loosen the nut (G, Figure 27) which holds the pinion gear bracket in the slotted hole.
2.If the pinion gear is too tight against the ring gear, move it away slightly and then retighten the nut.
3.Check the operation again.
Figure 27. Discharge Control |
| ||
A. | Pinion Gear | E. |
|
B. | Control Rod | F. | Ring Gear |
C. | Carriage Bolt | G. | Nut |
D. | Slotted Bracket |
|
|
CHUTE DIRECTION CONTROL GEAR BRACKET ADJUSTMENT
If the Discharge Chute becomes difficult to rotate or begins to operate erratically, the Chute Direction Control rod gears may require adjustment:
1.Loosen the gear bracket mounting screws (Figure 28).
2.Slide the gear bracket into the position that provides the best engagement between the gears.
3.Tighten the bracket mounting screws, and check for smooth operation.
4.Readjust if necessary.
5.Lubricate the Chute Direction Control rod gears with a medium weight (10W) oil.
Mounting Screws
Figure 28. Chute Direction Control Gear Bracket Adjustment
CHECKING TIRE PRESSURE
The air pressure in each tire (Figure 29) should be 20 psi (136 kPa) and should be equal for both tires for best per- formance. Be sure to keep caps on valves to prevent entry of debris into the valve stem when tires are filled.
Figure 29. Checking Tire Pressure
03
19