Al TE A OE
GENERA L RECONMENDATiONS | o._(C.A,.SAN0SPROCKETS) |
The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negli- gence To receive full value from the warranty, operator must maintain snow thrower as instructed in this manual.
Some adjustments wilt need to be made periodically to properly maintain your'snow thrower.
All adjustments in the Service and Adjustments section of this manual should be checked at least once each sea-
son
AFTER FIRST USE
eCheck the tracks for tension and adjust if necessary (See Adjust Track paragraph on page 21)_ Check the track adjustment and fasteners regularly
o Be sure that all fasteners are tight
HEX SHAFT
AS REQUIRED
The following adjustments should be performed more than once each season,,
eAuger'and Track Drive Belts should be adjusted after the first 2 to 4 hours of use and again about mid- season and twice each season thereafter. See To Adjust Belts paragraph on page 17,
eAll screws and nuts should be checked often to make sure they are tight, preferably after each use•
SNOW THROWER
LUBRICATION - EVERY TEN HOURS
®Chain and Sprockets- Oilchains and sprockets (See Fig. 15) with
LUBRICATION - NOT REQUIRED
oHex Shaft and Gears - Hex shaft and gear'srequire no lubrication. All bearings and bushings are lifetime lubricated and require no maintenance (See Fig. 16).
NOTE: Any greasing or oiling of the above components can cause contamination of the friction wheel. If the disc
drive plate or friction wheel come in contact with grease or oil, damage to the friction wheel will result..
Should grease or oil come in contact with the disc drive plate or friction wheel, be sure to clean the plate and wheel thoroughty_
NOTE: For storage, the hex shaft and gears should be wiped with
eAuger Gear Box - The auger gear box has been factory lubricated for life. If for some reason lubricant should leak out, have the auger gear'case checked by a competent repairman_
DISC DRI_¢E PLATE
FIG.16
14