Tecumseh OH195SP, LH318SA, OH358SA, OH195SA, LH358SA, LH195SP manual Emission Control System Warranty

Page 31

EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (“ECS Warranty”) for 1995 and later model year California small off-road engines (for other states, 1997 and later model year engines):

A. APPLICABILITY: This warranty shall apply to 1995 and later model year California small off-road engines (for other states, 1997 and later model year engines). The ECS Warranty Period shall begin on the date the new engine or equipment is delivered to its original, end-use purchaser, and shall continue for 24 consecutive months thereafter.

B.GENERAL EMISSIONS WARRANTY COVERAGE: Tecumseh Power Company warrants to the original, end-use purchaser of the new engine or equipment and to each subsequent purchaser that each of its small off-road engines is:

1.Designed, built and equipped so as to conform with all applicable regulations adopted by the Air Resources Board pursuant to its authority in Chapters 1 and 2, Part 5, Division 26 of the Health and Safety Code, and

2.Free from defects in materials and workmanship which, at any time during the ECS Warranty Period, will cause a warranted emissions-related part to fail to be identical in all material respects to the part as described in the engine manufacturer’s application for certification.

C.The ECS Warranty only pertains to emissions-related parts on your engine, as follows:

1.Any warranted, emissions-related parts which are not scheduled for replacement as required maintenance in the Operator’s Manual shall be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Tecumseh Power Company according to Subsection 4 below. Any such part repaired or replaced under the ECS Warranty shall be warranted for any remainder of the ECS Warranty Period.

2.Any warranted, emissions-related part which is scheduled only for regular inspection as specified in the Operator’s Manual shall be warranted for the ECS Warranty Period. A statement in such written instructions to the effect of “repair or replace as necessary”, shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

3.Any warranted, emissions-related part which is scheduled for replacement as required maintenance in the Operator’s Manual, shall be warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by Tecumseh Power Company according to Subsection 4 below. Any such emissions-related part repaired or replaced under the ECS Warranty, shall be warranted for the remainder of the ECS Warranty Period prior to the first scheduled replacement point for such emissions- related part.

4.Repair or replacement of any warranted, emissions- related part under this ECS Warranty shall be performed at no charge to the owner at a Tecumseh Authorized Service Outlet.

5.The owner shall not be charged for diagnostic labor which leads to the determination that a part covered by the ECS Warranty is in fact defective, provided that such diagnostic work is performed at a Tecumseh Authorized Service Outlet.

6.Tecumseh Power Company shall be liable for damages to other original engine components or approved modifications proximately caused by a failure under warranty of an emission-related part covered by the ECS Warranty.

7.Throughout the ECS Warranty Period, Tecumseh Power Company shall maintain a supply of warranted emission- related parts sufficient to meet the expected demand for such emission-related parts.

8.Any Tecumseh Power Company authorized and approved emission-related replacement part may be used in the performance of any ECS Warranty maintenance or repair and will be provided without charge to the owner. Such use shall not reduce Tecumseh Power Company ECS Warranty obligations.

9.Unapproved add-on or modified parts may not be used to modify or repair a Tecumseh Power Company engine. Such use voids this ECS Warranty and shall be sufficient grounds for disallowing an ECS Warranty claim. Tecumseh Power Company shall not be liable hereunder for failures of any warranted parts of a Tecumseh Power Company engine caused by the use of such an unapproved add-on or modified part.

EMISSION-RELATED PARTS INCLUDE THE FOLLOWING:

1.Carburetor Assembly and its Internal Components

a)Fuel filter

b)Carburetor gaskets

c)Intake pipe

2.Air Cleaner Assembly

a)Air filter element

3.Ignition System, including:

a)Spark plug

b)Ignition module

c)Flywheel assembly

4.Catalytic Muffler (if so equipped)

a)Muffler gasket (if so equipped)

b)Exhaust manifold (if so equipped)

5.Crankcase Breather Assembly and its Components

a) Breather connection tube

Revised April, 2005

IMPORTANT!

The emission Regulations may be different for your country. The emissions Control Warranty Statement is only applicable to engines with an emissions compliance statement and decal that references “Emissions Regulations”.

181-1275-14

4-Cycle • Snow King Engine

Page 29

Image 31
Contents 181-1275-14 English 08/01/05 Cycle Snow King Engine Operator’s ManualTable of Contents Avoid Gasoline Fires General Safety PrecautionsMaintenance Stay Away from Rotating PartsUse Hearing Protection Do not Modify EngineAvoid Burns and Fire from Hot Surfaces Avoid Accidental StartsEngine Identification Decal II. How to Get ServiceTecumseh Technician’s Handbooks Fuel III. Oil and Fuel SpecificationsIV. Before Starting Your Engine OilOil Fill Filling OilII. Oil Fill Check the Item Descriptions Check the Following ItemsOH318SA/OH358SA Filling Fuel Tank Electrical PowerStarting Your Engine Typical Engine SymbolsEngines with Electric Starters Stop LH195SA/LH195SP Engines with Recoil Starters Your WarrantyRecoil Starter Cord Handle Stop Engine VI. Stopping Your Engine Short-Term StorageAfter Engine is Stopped Remote Choke VII. MaintenanceChanging Oil Oil Fill Cap/Dipstick Oil Fill cap/Plug Oil Drain Plug Oil Fill Cap/DipstickUsed oil must be II. Oil Fill Cap/Plug Used oil must be disposed of at a proper collection center Spark PlugVIII. Transporting Your Engine Snow and Debris Removal Locations 181-1275-14 Draining Fuel Extended StorageIII. Fuel System IV. Fuel TreatmentII. Oil Cylinder Bore IV. BatteryIII. Oil Preventing Forest, Brush and Grass Fires XI. Maintenance IntervalsEvery 100 Hours or Seasonally 1. Check Spark Plug California & US EPA Emission Control Warranty Statement Emission Control System Warranty Consumer USE Commercial USE XII. Warranty Information

OH195SA, OH195SP, LH358SA, LH195SA, LH195SP specifications

The Tecumseh OH358SA, OH318SA, LH318SA, LH195SP, and LH195SA engines represent a range of high-performance power solutions designed primarily for outdoor equipment including lawn mowers, snow blowers, and other utility applications. These engines are crafted to meet the diverse needs of users, blending efficiency with reliability.

The OH358SA is a standout model featuring a powerful overhead valve (OHV) design that enhances performance while ensuring fuel efficiency. This engine is known for its air-cooled, single-cylinder configuration that delivers robust power. With a displacement of 358cc, it is capable of producing substantial torque, making it excellent for larger mowers and commercial-grade applications.

On the other hand, the OH318SA engine is a versatile alternative equipped with similar principles of efficiency and power. With a displacement of 318cc, it is designed for medium-duty equipment, providing sufficient grunt for residential mowing tasks and light commercial usage. Its compact size and lightweight design contribute to improved maneuverability, which is advantageous in tight spaces.

The LH318SA takes the durability of the OH318SA a step further by integrating a heavy-duty crankshaft and reinforced components. This model is particularly suited for harsh working conditions, combining a robust build with an innovative air filtration system that prolongs engine life by maintaining cleanliness in critical areas.

The LH195SP and LH195SA models gear towards smaller applications, offering a balance between performance and weight. Both engines feature a 195cc displacement, making them ideal choices for lightweight equipment. The LH195SP is particularly designed with self-propelling mechanisms in mind, enabling effortless operation of lawn mowers and similar devices.

In terms of technologies, all these models leverage Tecumseh’s commitment to engineering excellence, incorporating sound dampening features for reduced noise levels and enhanced user comfort. They are also equipped with easy-start technology, ensuring that even novice users can get going without cumbersome procedures.

The combination of high-quality materials, ergonomic designs, and technological innovations ensures that Tecumseh engines remain reliable under various loads and operating conditions. These characteristics make them a preferred choice among professionals and homeowners alike, ensuring reliability and efficiency in outdoor tasks. Whether tackling large fields with the OH358SA or maintaining small lawns with the LH195SA, there’s a Tecumseh engine designed to meet every user's demands.