Stiga 8218-2220-70 manual Symbols, Safety Instructions, General, Preparations, Operation

Page 4

ENGLISH

1 SYMBOLS

The following symbols appear on the machine. They are there to remind you of the care and attention required in use.

This is what the symbols mean: Warning.

Read and understand the owner’s manual before using this machine.

Disconnect the spark plug wire, and consult technical literature before performing repairs or maintenance.

Danger - rotating fan.

Danger - rotating auger.

Keep hands out of discharge chute.

Keep hands and feet away from rotating parts.

Risk of burns.

Keep bystanders at a safe distance from the machine.

Never point the discharge chute towards bystanders.

Use hearing protection.

2 SAFETY INSTRUCTIONS

2.1GENERAL

Please read through these instructions carefully. Learn all the controls and the correct use of the machine.

Never allow children or anyone who is not familiar with these instructions to use the snow thrower. Local regulations may impose restrictions as regards the age of the driver.

Never use the machine if others, particularly children or animals, are in the vicinity.

Remember that the driver is responsible for accidents that happen to other people or their property.

Be careful not to trip or fall, especially when reversing the machine.

Never use the snow thrower under the influence of alcohol or medication and if you are tired or ill.

40

2.2PREPARATIONS

Check the area to be cleared and remove any loose or foreign objects.

Disengage all controls before starting the engine.

Never use the snow thrower unless properly dressed. Wear footwear that improves your grip on a slippery surface.

Warning – Petrol is highly inflammable.

a.Always store petrol in containers that are made especially for this purpose.

b.Only fill or top up with petrol outdoors, and never smoke when filling or topping up.

c.Fill with petrol before starting the engine. Never remove the filler cap or fill with petrol while the engine is running or still warm.

d.Screw the filler cap on tightly and wipe up any spilt petrol.

Adjust the height of the auger housing to ensure it stays above gravel paths.

Never, under any circumstances, make adjustments while the engine is running (unless otherwise specified in the instructions).

Allow the snow thrower to adjust to the outdoor temperature before using it.

Always use protective goggles or a visor during use, maintenance and service.

2.3OPERATION

Keep hands and feet away from rotating parts. Always avoid the discharge chute opening.

Be careful when driving on or crossing gravel paths, pavements and roads. Be aware of hidden dangers and traffic.

Never direct the discharge chute towards a public road or traffic.

If the snow thrower hits a foreign object, stop the engine, disconnect the spark plug cable and carefully inspect the machine for damage. Repair the damage before using the machine again.

If the machine starts vibrating abnormally, stop the engine and look for the cause. Vibration is normally a sign of something wrong.

Stop the engine and disconnect the spark plug cable:

a.If the machine steers away from the driving position.

b.If the auger housing or discharge chute is blocked and must be cleaned.

c.Before beginning repairs or adjustments.

Always make sure the rotating parts have stopped and all the controls are disengaged before cleaning, repairing or inspection.

Before leaving the machine unattended, disengage all the controls, put it into neutral gear, stop the engine and remove the ignition key.

Never run the engine indoors except when taking it in and

Image 4
Contents Stiga Page Page Symbols Safety InstructionsGeneral PreparationsAssembly Controls Using the Snow Thrower Maintenance Service and RepairsAdjusting the Scraper Blade and Shoes Adjusting the Control WiresGeneral about Drive Belts Replacing the Auger BeltPurchase Terms StorageIf Something Breaks W. s t i g a . c o m