Troy-Bilt 10530 manual Replacing Belts, Auger Belt

Page 16

Shear Bolts

 

 

Carriage Bolt

Flange Lock Nut

Shave Plate

 

Figure 17

Reassemble the new shave plate, making sure heads of carriage bolts are to the inside of the housing. Tighten securely.

Replacing Belts

To remove and replace either the auger belt or the drive belt, follow the steps below and then proceed to the specific steps listed under respective sub-headings.

Disconnect the chute directional control at the chute assembly base by removing the hairpin clip and the flat washer. See Figure 18.

Remove the plastic belt cover, located near the engine, by removing the three self-tapping screws and flat washers that secure it. See Figure 18.

Hairpin

Flat

Belt Cover Screws(3)

Belt Cover

Clip

Washer

 

 

 

 

 

 

 

 

 

 

Upper Bolt

 

 

Shoulder Bolt

(remove)

 

 

(do not remove)

 

 

Figure 18

Remove the large shoulder bolt and washer on the left hand side of the engine pulley. See Figure 19.

Engine Pulley

Shoulder Bolt

Figure 19

Auger Belt

Remove the cotter pin and washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly. See Figure 20.

Engine

 

Pulley

Auger Control

 

Auger Idler

Belt

 

Rod

 

Ferrule

 

Brake Bracket

 

Assembly

Cable Roller

 

Z Fitting

Guide

 

Figure 20

Slip the auger control belt (the front belt) off the engine pulley.

Pull the brake bracket assembly towards the cable guide roller and unhook the auger cable “Z” fitting.

Remove the upper bolts and lock washers which secure the auger housing assembly to the frame assembly using a 9/16” wrench. See Figure 18.

Separate the auger housing from the frame assembly by tilting the housing forward and pulling up the handles.

Using a 1/2” wrench, remove the hex bolt and bell washer from the center of the pulley on the auger housing. Lift the brake bracket assembly out of the pulley groove and remove the pulley. Be careful not to lose the key. See Figure 21.

16

Image 16
Contents Operator’s Manual Table of Contents Important Safe Operation Practices TrainingMaintenance and Storage Hardware Pack Assembling Your Snow ThrowerAssembling Handle Attaching Chute Assembly Hardware Group a Attaching Chute Directional ControlKnow Your Snow Thrower Routing Chute Tilt CablesAuger Control Chute Tilt ControlChute Directional Control HeadlightsOperating Your Snow Thrower Before Starting Gas And Oil Fill-upTo Start Engine Electric StarterTo Engage Augers To Stop EngineAuger Control Test Making Adjustments Clean-Out ToolTo Engage Wheel Drive Operating TipsShift Rod Tire Pressure Pneumatic TiresSkid Shoe Adjustment Chute AssemblyMaintaining Your Snow Thrower General RecommendationsCheck V-Belts LubricationServicing Your Snow Thrower Bonded Friction WheelAugers Shave Plate and Skid ShoesReplacing Belts Auger BeltChanging Bonded Friction Wheel Drive BeltOff-Season Storage Troubleshooting Problem Cause RemedyParts List for Model Model 2122 Model Model Auger/Drive Cable Assembly Description Model 714-0507 Cotter Pin Page Page MANUFACTURER’S Limited Commercial Warranty For MANUFACTURER’S Limited Warranty for