Troy-Bilt 10530 manual Off-Season Storage

Page 18

A

Shift Arm Assembly

 

 

Sprocket

 

Hex Shaft

Spacer

 

 

 

Pin

 

 

Friction Wheel

 

B

Hub

Plate

 

 

 

 

Bearing

 

Screws

 

 

Bonded Friction

 

 

Wheel

 

Figure 23

 

Sprocket

Hex Shaft

 

Hex Hub

Spacer

Of Sprocket

 

Figure 24

NOTE: If the sprocket fell from the snow thrower while removing the hex shaft, place the sprocket on the hex shaft. Position the hex hub of the sprocket toward the friction wheel when sliding the sprocket on to the hex shaft. See Figure 24.

Secure with the bell washer and hex bolt removed earlier.

Secure the frame cover with six self-tapping screws. Put the snow thrower down to its normal operating position.

NOTE: If you placed plastic film under the gas cap, be certain to remove it.

Off-Season Storage

WARNING: Never store engine with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or other gas appliance.

If unit is to be stored over 30 days, prepare engine for storage as instructed in the engine manual.

Remove all debris from the exterior of equipment.

Follow lubrication recommendations on page 14.

Always store the snow thrower in a clean, dry area.

NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rust proof the equipment. Using a light oil or silicone, coat the equipment, especially any chains, springs, bearings, and cables.

18

Image 18
Contents Operator’s Manual Table of Contents Important Safe Operation Practices TrainingMaintenance and Storage Assembling Your Snow Thrower Hardware PackAssembling Handle Attaching Chute Assembly Hardware Group a Attaching Chute Directional ControlKnow Your Snow Thrower Routing Chute Tilt CablesChute Directional Control Auger ControlChute Tilt Control HeadlightsTo Start Engine Operating Your Snow ThrowerBefore Starting Gas And Oil Fill-up Electric StarterTo Stop Engine To Engage AugersAuger Control Test To Engage Wheel Drive Making AdjustmentsClean-Out Tool Operating TipsShift Rod Tire Pressure Pneumatic TiresSkid Shoe Adjustment Chute AssemblyCheck V-Belts Maintaining Your Snow ThrowerGeneral Recommendations LubricationAugers Servicing Your Snow ThrowerBonded Friction Wheel Shave Plate and Skid ShoesReplacing Belts Auger BeltChanging Bonded Friction Wheel Drive BeltOff-Season Storage Troubleshooting Problem Cause RemedyParts List for Model Model 2122 Model Model Auger/Drive Cable Assembly Description Model 714-0507 Cotter Pin Page Page MANUFACTURER’S Limited Commercial Warranty For MANUFACTURER’S Limited Warranty for