Troy-Bilt 10530 Attaching Chute Directional Control, Attaching Chute Assembly Hardware Group a

Page 6

Shift Rod

Connector

Carriage Bolt

Bell Washer

Wing Nut

Springs

Actuator Brackets and Springs

Figure 3

Attaching Chute Assembly (Hardware Group A)

Place chute assembly over chute opening, with the opening in the chute assembly facing the front of the unit.

Place chute flange keepers beneath lip of chute assembly, with the flat side of chute flange keeper facing downward.

Insert hex screw up through chute flange keeper and chute assembly and secure with hex lock nut. After assembling all three chute flange keepers, tighten all nuts and screws securely with two 7/16” wrenches. Do not overtighten. See Figure 4A.

With the lock nuts loosened on the lower chute rod bracket (See Figure 4B) adjust the bracket so that the spiral fully engages the teeth on the chute assembly. Tighten the lock nuts on the lower chute rod bracket securely.

A

Chute Assembly

 

Hex Screw

 

Hex Lock Nut

 

Chute Flange

 

Keeper

B

Chute Directional

 

Control

 

Spiral

Chute

 

Assembly

 

Lower Chute

 

Rod

 

Bracket

Lock Nuts

 

Figure 4

Attaching Chute Directional Control

Remove the hairpin clip from the upper chute rod and slide the upper chute rod through the upper chute rod bracket and into the lower chute rod. See Figure 5.

Align the two holes on both chute rods and insert the hairpin clip removed earlier, through these holes. See Figure 5.

Upper Chute Rod

Upper Chute

Rod Bracket

Hairpin Clip

Lower Chute Rod

Figure 5

6

Image 6
Contents Operator’s Manual Table of Contents Important Safe Operation Practices TrainingMaintenance and Storage Assembling Your Snow Thrower Hardware PackAssembling Handle Attaching Chute Assembly Hardware Group a Attaching Chute Directional ControlKnow Your Snow Thrower Routing Chute Tilt CablesChute Directional Control Auger ControlChute Tilt Control HeadlightsTo Start Engine Operating Your Snow ThrowerBefore Starting Gas And Oil Fill-up Electric StarterTo Stop Engine To Engage AugersAuger Control Test To Engage Wheel Drive Making AdjustmentsClean-Out Tool Operating TipsShift Rod Tire Pressure Pneumatic TiresSkid Shoe Adjustment Chute AssemblyCheck V-Belts Maintaining Your Snow ThrowerGeneral Recommendations LubricationAugers Servicing Your Snow ThrowerBonded Friction Wheel Shave Plate and Skid ShoesReplacing Belts Auger BeltChanging Bonded Friction Wheel Drive BeltOff-Season Storage Troubleshooting Problem Cause RemedyParts List for Model Model 2122 Model Model Auger/Drive Cable Assembly Description Model 714-0507 Cotter Pin Page Page MANUFACTURER’S Limited Commercial Warranty For MANUFACTURER’S Limited Warranty for