White Outdoor SB 45 manual Assembling Your Snow Thrower

SECTION 2: ASSEMBLING YOUR SNOW THROWER

Unpacking from carton

•Cut along corners of the carton and lay it down flat. See Figure 1. Remove packing material.

•Remove any loose parts included with unit (i.e., operator’s manual, etc.).

•Roll unit out of carton. Check carton thoroughly for any remaining loose part.

Remove loose parts

Roll unit out

Figure 1

Hardware pack (Figure 2)

1. Ignition Keys (2)

NOTE: One key is in the switch on the snow thrower.

2.Eyebolt

3.Saddle Washer 5/16" I.D.

4.Hex Nuts 5/16-18 Thread (2)

5.Cotter Pin

			Hex Nut
Ignition		Saddle
		Washer		Cotter
Key
	Eye Bolt			Pin

Figure 2

Items required for assembly

1.Pair of pliers (not necessary, but helpful)

2.Two cycle engine oil

3.Fresh gasoine

NOTE: All references to left or right side of the snow thrower is from the operating position only.

Raising upper handle

•Loosen the hand knob on each side of the handle. Remove packing material, if any.

Raise handle to here

Hand Knob

Figure 3

•Raise the upper handle in the direction shown in Figure 3 till it clicks into the operating position. Make sure not to pinch or crimp the cable.

•Tighten the hand knobs.

Attaching control cable

The control cable may already be attached to the control handle. If not attached, complete the following steps to attach it to the snow thrower housing.

Bottom	“Z” End
	of Cable
Hole In
Control
Handle
Control
		Plastic
Housing
		Fitting

Figure 4

•Route the control cable over the lower handle. Insert the end of the cable into the hole in the control housing as shown in Figure 4. Push the plastic fitting until it locks into the control housing.

•Lift the control handle up, and hook the “Z” end of the control cable into the bottom hole in the control handle, from the outside to the inside. If necessary, pull up on the end of the cable with a pair of pliers to obtain slack in order to hook it into

5