Unpacking and SET-UP

1.Be sure carton is right side UP. cut end panels out and fold flat on floor. Remove inner pack and roll unit out of carton.2.

Assemble right and left handle tubes to the unit with bolts and flat washers. Do not tighten.

3.Assemble handle panel assembly to the under side of right and left handle tubes and secure with four slotted hex head bolts and lock nuts. Tighten all bolts on the handle assembly. Place handle grips over ends of the handle tubes.

4.Assemble chute adjustment shaft through hole in the handle panel and into uni";'ersaljoint. located on lef! hand side of the frame. Align hole in universal joint with the hole in chute adjustment shaft and drive spring pin through the holes.

5.Attach master cl~tch rod adjusting link into the bottom

hole of master clutch control located			on .the. handle"panel'andi~""t(.."'-"';)"."';"
		.'J.		':
-,;"'*-""""',"'"	-..'
	..Move		I	..

.1ever forward to. thf! end o.f"the not6h To. adjust:,. remove cotter pin from clutch lever adjustment link and thread op or down until the link is the full hole short of reach- ing the hole in tl)e clutch lever. Move .clutch lever back slightly to. rec9nnect link.. Replace Go.tter pin and spread.

6.Remove rubber shift lever panel from parts package and slip over end of shifting lever. I nsert shifting lever into back of rear cover and slip small shifting rod through bushing in end of lever. Secure shift lever to mounting bracket with bolt, washer, bushing, and nut. Assemble t.hreaded rod into end of shift lever through handle panel, locking rod in position with nut. Assemble plastic knob onto shift lever rod. Snap rubber shift lever panel into rear frame cover holes. Refer to Page 7 to make adjustment of shift lever panel no~ches.