Chute Chain and Adjustment

REPLACING SAFETY SHEAR BOLT

If the intake snow reel should jam causing the safety shear bolt to shear, it may be replaced with a new bolt, furnished in the parts bag, after removing the broken pieces in the shaft. NOTE: Always align the hole in the reel shaft and the sprocket shaft before driving out the broken bolt.

To tighten the chute chain, rotate the chute all the way to the left, until the adjustment bolt is accessible.Tighten the adjustment nut to tighten the chain.

CAUTION: Chain should be kept snug on chute housing.

CHUTE CABLE ADJUSTMENT

Remove cable roller cover, loosen the locking bolt on top of the cable roller bracket and tighten the adjustment bolt on the side.

CAUTION: The cable should not be adjusted too tightly, adjustment should allow the spout to rotate freely. R.e~ightenth~ locking bolt and replace the cable r~ller cover.

-..:\."~,\,-"..' .~.4n:",;.,_: ! :~ "...,,'.";", ",~"""'~H.I

~"T"-:;iNii~ liST"iE~NT"", ..~~.

To set .or adjust .the shift panel for correct speeds, place master clutch control in neutral position and the shift lever into the fifth speed notch. loosen ~he'two mounting bolts and push sh.ift lever. right as far as ~llowed, hold,. and tighten mounting bolts. DO NOT ATTEMPT THIS AD- JUSTMENT WITH THE ENGINE RUNNING. To check adjustment, start engine, move shift lever to first speed notch and engage master clutch control. Unit should move forward .very slowly.

NOTE: Adjustment section continued on page12.