Craftsman 536.88502 owner manual Chute Flange, Sembly INCORRECTt.Y and Snow could be DIS

ASSEMBLY

i i iiiii lUU i iiiillU, UUl i i ii ii iiill

TO iNSTALL CHUTE ASSEMBLY TO

CHUTE FLANGE

CHUTE

ASSEMBLY

Q Remove the chute assembly from the carton

•_Usinga 1/2 inch wrench or adjustable wrench, re- move the three (3) nuts, Iockwashers, flatwashers and carriage bolts from the chute flange°

®PPlacethe chute assembly over the outside of the _chute flange so that the "A" on the chute assembly is next to the "A" on the chute flange This will al+gn 'al!three holes correctly+

•_.Fromthe inside of the chute flange, insert the three

[(3) carriage bolts (removed earlier) through the

\

ithree square holes The square part of the carnage bolls should fit into the square holes in the chute

+!lange+

®.lnstall the three (3) flatwashers, !ockwashers and

'nuts(removed earlier) on the carriage bolts. t

: ._,Juu.ltl

CAUTION: IF ALL THE THREE (3) CARRIAGE

'_ BOLTS CANNOT BE MOUNTED, THE HOLES ARE NOT ALIGNED CORRECTLY.CHECK THE

POSITION OF THE LETTER "A's"ON THE CH_JTEASSEMBLY AND CHU_ FLANGE. THEY MUST

BE NEXT TO EACH OTHER+IF LESS THAN THREE (3) HOLES LINE UP,YOU HAVE MOUNTED THE CHUTE AS-

SEMBLY INCORRECTt.Y AND SNOW COULD BE DIS-

CHARGED TOWARD THE OPERATOR.RE+INSTALLTHE CHUTE ASSEMBLY IF NECESSARY.

NUT

LOCKWASHER

FLATWASHER CARRIAGE

BOLT

(SHOWN

CHUTt

SQUARE

HOLE IN

CHUTE FLANGE

A

FIG. 8

t

<

10