
The operation of any snow thrower can re- sult in foreign objects being thrown into the eyes, which can result in severe eye dam- age. Always wear safety glasses or eye shields while operating the snow thrower.
We recommend standard safety glasses or a wide vision safety mask for over your glasses, available at Craftsman Retail Stores or Service Centers.
L_ CAUTION: Read owner'smanual
before operating machine. Never direct discharge toward bystanders. Release the auger control bar and stop the engine before unclogging discharge chute or auger housing and before leaving the machine,
HOWTO USEYOUR SNOW
THROWER
TO STOP YOUR SNOW THROWER
•To stop throwing snow, release the auger drive lever (see last figure on this page).
•To stop the wheels, release the traction drive lever (see last figure on this page).
•To stop the engine, push the throttle con- trol lever to off and pull out (DO NOT TURN) the ignition kay, see figure below.
button | c Starter Button |
Ignition
control;tarter handle
TO CONTROL SNOW DISCHARGE
•Turn the crank assembly to set the direc- tion of the snow throwing.
•Loosen the wing knob on the chute de- flector and move the deflector to set the
distance. Move the deflector (UP) for more distance, (DOWN) for less distance.
Then tighten the wing knob, see figure below.
TO MOVE FORWARD AND
BACKWARD
•To shift, release the traction drive lever and move the speed shifter lever to the speed you desire. Ground speed is deter- mined by snow conditions. Select the speed you desil'eby moving the speed shifter lever into the appropriate area on the speed selector.
Speeds 1,2 - Wet, Heavy, Extra Deep
Speed 3 + Light
Speed 4 - Very Light
Speeds 5, 6 - Transport only
•Engage the traction drive lever as shown
in figure below, left hand. As the snow thrower starts to move, maintain a firm
hold on the handles, and guide the snow
thrower along the clearing path. Do not at- tempt to push the snow thrower.
•To move the snow thrower backward, move the speed shifter lever into first or second reverse and engage the traction drive lever (left hand).
IMPORTANT: Never move the speed shifter lever while the traction lever is down.
TOTHROW SNOW '
•Push down the auger drive lever, see fig- ure below.
•Release to stop throwing snow.
Traction Drive Lever | Auger Ddve Lever |
Off | Off |
On
Left hand | Right hand |
TO USE WHEEL LOCKOUT PIN
•The left hand wheel is secured to the axle with a klick pin see figure below. This unit was shipped with this klick pin in the locked position (kllck pin through hole In wheel).
knob
Locked
Position
KlickPin
10