CAUTION: Always wear safety glasses or eye shields while assembling snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton
The figure to the right shows the snow thrower completely assembled. References to the right or left hand side
of the snow thrower are from the viewpoint of the operator'sposition behind the unit.
TO REMOVE SNOW THROWER FROM CARTON
•Locate and remove container of Crafts- man
•Remove the inserts positioned around the unit and the packing material.
•Cut down two comers nearest the handles and lay the panel down flat.
•Remove and discard bottom packaging.
•Pug snow thrower out of the carton.
TO ASSEMBLE THE SNOW
THROWER
•Remove wrap on upper handle and along the side of both handles. Discard wrap.
•Unfold upper handle to remove packaging on the control panel and discard.
•Loosen the tee knobs on each side of the upper handle. See figure on this page.
•Raise the upper handle to the operating
position.
NOTE: Make sure the cables are not caught between the upper and lower handle.
•Check to be sure the clutch cable is not caught in the handle. Tighten the tee knobs.
Chute Control Rod
\
CHECKLIST
Before you operate your new snow thrower, to ensure that you receive the best perfor- mance and satisfaction from this quality product, please review the following checklist:
J" All assembly instructions have been completed.
,/ The discharge chute rotates freely. ,I No remaining loose parts in carton.
While learning how to use your snow thrower, pay extra attention to the following important items:
,/,/ Make sure gas tank is filled with 40:1 ratio mixture of gasoline and oil.
./,/ Become familiar with all