Husqvarna 5021 R, 5021 E manual HOW to Replace the Drive Belt

Page 22

MAINTENANCE

5 1

6 2

3

6

3

4

3

3

Figure 8

HOW TO REPLACE THE DRIVE BELT

The drive belt is of special construction and must be replaced with original factory replacement belt avail- able from your nearest authorized service center.

1.Remove the belt cover. See “How To Remove The Belt Cover.”

2.(Figure 9) Remove the drive belt (1) from the idler pulley (2).

3.Move the belt guide (4) away from the drive belt (1).

4.To reduce pressure on the drive belt (1), move the idler pulley (2) away from the drive belt (1). Remove the drive belt (1) from between the brake pad (3) and the roller (5).

5.Remove the old drive belt (1).

6.To install the new drive belt (1), reverse the above steps.

7.Make sure the drive belt (1) is seated properly on the pulleys.

8.(Figure 10) Set the belt guide (1) to 3/32” clearance.

NOTE: When the auger control lever is en- gaged, the belt guide (1) must be 3/32” (2 mm) from the drive belt (2).

9.Install the belt cover. See “How To Remove The Belt Cover.”

2

3

4

5

1

Figure 9

 

2

3/32” 1

Figure 10

1741506

22

Image 22
Contents Operator’s Manual Introduction Responsibility of the OwnerHazard Symbols and the meanings Rules for Safe OperationTraining Children Table of Contents Safety Decals Decals OWNER’S Information Warranty Statement Limited WarrantyItems not Covered by this Warranty Tools Required for Assembly AssemblyParts BAG Contents HOW to Remove the Snowthrower from the CartonADD OIL to the Engine ADD Fuel to the EngineBefore YOU Operate Know Your SnowthrowerControl and Equipment Features Figure OperationHOW to Stop Discharging Snow HOW to Control Discharge SnowHOW to Throw Snow HOW to Move ForwardHOW to Start a Cold Engine HOW to Stop the EngineHOW to Start the Engine Before Starting the EngineHOW to Start a Warm Engine with a Frozen Starter HOW to Start a Warm EngineHOW Clear a Clogged Discharge Chute Dry and Average Snow Customer Responsibilities MaintenanceEngine Power Rating Information Emissions ControlHOW to Remove the TOP Cover Lubrication Before StorageHOW to Adjust the Auger Control Cable HOW to Remove the Belt CoverHOW to Replace the Drive Belt HOW to Replace the Auger HOW to Adjust the Brake PADHOW to Replace the Spark Plug HOW to Prepare the Snowthrower for StorageHOW to Order Replacement Parts Troubleshooting Chart Trouble Cause CorrectionEngine And Frame Assembly 0003REF no Description Engine And Frame Assembly SPACER, Drive Pulley Auger And Control Assembly 0005COVER, TOP Discharge Chute 0007Chute Ring Handle Assembly 0011HANDLE, Upper Chute Rod Assembly 0009ROD, Chute Decals 0015DECAL, Warning HOT Muffler Wheels 0013RING, Retainer E