Husqvarna 5021 E, 5021 R manual HOW to Order Replacement Parts

Page 25

MAINTENANCE

6.Be sure that all nuts, bolts, and screws are securely fastened. Inspect all visible moving parts for damage, breakage, and wear. Replace if necessary.

7.Cover the bare metal parts of the blower housing and auger with spray rust pre- ventative lubricant.

8.Put the unit in a building that has good ventilation.

9.If the machine must be stored outdoors, block up the snow thrower to be sure the entire machine is off the ground.

10.Cover the snow thrower with a suitable protective cover that does not retain moisture. Do not use plastic.

HOW TO ORDER REPLACEMENT PARTS

Use only manufacturer’s authorized or approved replacement parts. Do not use attachments

or accessories not specifically recommended for this unit. In order to obtain proper replacement you must supply the model number (see nameplate).

Warranty service is available only through Authorized Service Dealers.

1741506

25

Image 25

Contents Operator’s Manual Responsibility of the Owner IntroductionRules for Safe Operation Hazard Symbols and the meaningsTraining Children Table of Contents Safety Decals Decals Limited Warranty OWNER’S Information Warranty StatementItems not Covered by this Warranty Parts BAG Contents AssemblyTools Required for Assembly HOW to Remove the Snowthrower from the CartonADD Fuel to the Engine ADD OIL to the EngineKnow Your Snowthrower Before YOU OperateOperation Control and Equipment Features FigureHOW to Throw Snow HOW to Control Discharge SnowHOW to Stop Discharging Snow HOW to Move ForwardHOW to Start the Engine HOW to Stop the EngineHOW to Start a Cold Engine Before Starting the EngineHOW to Start a Warm Engine with a Frozen Starter HOW to Start a Warm EngineHOW Clear a Clogged Discharge Chute Dry and Average Snow Engine Power Rating Information MaintenanceCustomer Responsibilities Emissions ControlLubrication Before Storage HOW to Remove the TOP CoverHOW to Remove the Belt Cover HOW to Adjust the Auger Control CableHOW to Replace the Drive Belt HOW to Adjust the Brake PAD HOW to Replace the AugerHOW to Prepare the Snowthrower for Storage HOW to Replace the Spark PlugHOW to Order Replacement Parts Trouble Cause Correction Troubleshooting Chart0003 Engine And Frame AssemblyREF no Description Engine And Frame Assembly SPACER, Drive Pulley 0005 Auger And Control AssemblyCOVER, TOP 0007 Discharge ChuteChute Ring 0011 Handle AssemblyHANDLE, Upper 0009 Chute Rod AssemblyROD, Chute 0015 DecalsDECAL, Warning HOT Muffler 0013 WheelsRING, Retainer E