Husqvarna 12524SB manual Crushed rock surface, Never attempt to make any adjustments while

Page 2

IMPORTANT

Safe Operation Practices for Walk-Behind Snow Throwers

This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury.

Look for this symbol to point out im- portant safety precautions. It means CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in order to prevent acci- dental starting when setting up, trans- porting, adjusting or making repairs.

WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surfaces. Caution should be exercised while using on sloping sur- faces. Do not use snow thrower on surfaces above ground level such as roofs of residences, garages, porches or other such structures or buildings.

WARNING: Snow throwers have ex- posed rotating parts, which can cause severe injury from contact, or from ma- terial thrown from the discharge chute. Keep the area of operation clear of all persons, small children and pets at all times including startup.

CAUTION: Muffler and other engine parts become extremely hot during operation and remain hot after engine has stopped. To avoid severe burns on contact, stay away from these areas.

WARNING: Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemi- cals known to the State of California to cause cancer and birth defects or other reproductive harm.

Training

1. Read, understand and follow all instructions on the

 

(f) Keep the nozzle in contact with the rim of the fuel

machine and in the manual(s) before operating this

 

tank or container opening at all times, until refuel-

unit. Be thoroughly familiar with the controls and the

 

ing is complete. Do not use a nozzle lock-open

proper use of the equipment. Know how to stop the

 

device.

unit and disengage the controls quickly.

 

(g) Replace gasoline cap securely and wipe up spilled

2. Never allow children to operate the equipment. Never

 

fuel.

allow adults to operate the equipment without proper

 

(h) If fuel is spilled on clothing, change clothing im-

instruction.

 

 

mediately.

3. Keep the area of operation clear of all persons, par-

 

5. Use extension cords and receptacles as specified by

ticularly small children.

 

the manufacturer for all units with electric drive motors

 

 

 

4. Exercise caution to avoid slipping or falling, especially

 

or electric starting motors.

when operating the snow thrower in reverse.

6. Adjust the collector housing height to clear gravel or

Preparation

 

crushed rock surface.

7. Never attempt to make any adjustments while the

1. Thoroughly inspect the area where the equipment is

 

engine (motor) is running (except when specifically

to be used and remove all doormats, sleds, boards,

 

recommended by manufacturer).

wires, and other foreign objects.

8. Always wear safety glasses or eye shields during op-

2. Disengage all clutches and shift into neutral before

 

eration or while performing an adjustment or repair to

starting the engine (motor).

 

protect eyes from foreign objects that may be thrown

3. Do not operate the equipment without wearing adequate

 

from the machine.

winter garments. Avoid loose fitting clothing that can

Operation

get caught in moving parts. Wear footwear that will

improve footing on slippery surfaces.

1. Do not put hands or feet near or under rotating parts.

4. Handle fuel with care; it is highly flammable

 

Keep clear of the discharge opening at all times.

(a)

Use an approved fuel container.

2. Exercise extreme caution when operating on or cross-

(b)

Never add fuel to a running engine or hot en-

 

ing gravel drives, walks, or roads. Stay alert for hidden

 

hazards or traffic.

 

gine.

 

 

3.

After striking a foreign object, stop the engine (motor),

(c) Fill fuel tank outdoors with extreme care. Never fill

 

remove the wire from the spark plug, disconnect the

 

fuel tank indoors.

 

 

 

cord on electric motors, thoroughly inspect the snow

(d) Never fill containers inside a vehicle or on a truck

 

 

thrower for any damage, and repair the damage before

 

or trailer bed with a plastic liner. Always place

 

restarting and operating the snow thrower.

 

containers on the ground, away from your vehicle,

4. If the unit should start to vibrate abnormally, stop the

 

before filling.

 

 

engine (motor) and check immediately for the cause.

(e)

When practical, remove gas-powered equipment

 

 

Vibration is generally a warning of trouble.

 

from the truck or trailer and refuel it on the ground.

5.

Stop the engine (motor) whenever you leave the oper-

 

If this is not possible, then refuel such equipment

on a trailer with a portable container, rather than

 

ating position, before unclogging the collector/impeller

 

housing or discharge chute, and when making any

from a gasoline dispenser nozzle.

 

2

repairs, adjustments or inspections.

 

 

 

Page 1 Page 3
Image 2
Page 1 Page 3
Contents 12524SB Engine motor is running except when specifically Never attempt to make any adjustments whileThoroughly inspect the area where the equipment is Crushed rock surfaceTable of Contents Parts Packed Separately in Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Remove Snow Thrower from CartonUnfold Upper Handle Install Speed Control ROD See FigsInstall Traction Drive Control ROD See Figs Check Tire Pressure Install Auger Control ROD See FigsInstall Discharge Chute / Chute Rotater Head See Fig Primer OperationKnow Your Snow Thrower Ignition KEYElectric start button used for starting the engine Meets A.N.S.I. Safety RequirementsSkid plate used to adjust height of scraper bar from Ground To USE Fuel SHUT-OFF Valve See Fig HOW to USE Your Snow ThrowerStopping To USE Choke Control See FigTo Throw Snow See Fig Using the CLEAN-OUT Tool See FigTo Adjust Skid Plates See Fig Release the auger control lever and shut off the engineCheck Engine OIL Level See Fig Before Starting the EngineScraper BAR See Fig ADD Gasoline See FigIf Recoil Starter has Frozen Snow Throwing TipsBefore Stopping Before Each USE MaintenanceGeneral Recommendations LubricationCleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Carburetor To Adjust Cable Tension See FigTo Remove Wheels See Fig Engine SpeedFuel System StorageOther Engine OILTroubleshooting Warranty Statement 532 42 85-35 06.17.09 CL

12524SB specifications

The Husqvarna 12524SB is a powerful and versatile snow thrower designed to tackle even the toughest winter conditions. Built for homeowners seeking efficiency and reliability, this machine stands out for its impressive performance and innovative features.

At the heart of the 12524SB is a robust 291cc engine that provides exceptional power. This engine ensures that snow is cleared quickly and effectively, capable of handling heavy snowfall with ease. The electric start feature allows for convenient operation in frigid temperatures, enabling users to start the machine with a simple push of a button, eliminating the hassle of pull-starting in the cold.

One of the defining characteristics of the Husqvarna 12524SB is its powerful clearing system. With a 24-inch clearing width and the ability to throw snow up to 33 feet, this snow thrower is perfect for driveways and sidewalks. The reinforced steel auger quickly breaks up compacted snow and ice, while the high-speed impeller maximizes throwing distance, making it suitable for various snow conditions.

The machine features an adjustable skid shoe design, allowing users to customize the height of the auger for optimal performance on different surfaces. This adaptability is particularly useful for preserving the integrity of driveways and sidewalks, as it minimizes damage to underlying surfaces while effectively removing snow.

Husqvarna has incorporated user-friendly controls into the 12524SB design. The ergonomic handlebar provides comfort during operation, reducing fatigue during long periods of use. Additionally, the remote chute control allows for quick and easy adjustments to the direction of the snow discharge without needing to stop the machine.

Another key feature is the LED headlights, which enhance visibility during late-night or early-morning snow removal tasks. This ensures that users can operate the snow thrower safely and effectively, regardless of the time of day.

Durability is also a strong point for the Husqvarna 12524SB. Constructed with high-quality materials, the machine is built to withstand harsh winter conditions, ensuring reliability for years to come.

In summary, the Husqvarna 12524SB is a feature-rich snow thrower, combining a powerful engine, efficient clearing capabilities, and user-friendly design. Its array of innovative technologies makes it an excellent choice for homeowners looking to invest in a dependable snow removal solution that can handle even the heaviest snowfalls. Whether navigating long driveways or tackling sidewalks, the 12524SB is designed to make winter maintenance a breeze.
Top Page Image Contents