Husqvarna ST 330T warranty Maintenance, General Recommendations, Before Each USE, Lubrication

Page 16

MAINTENANCE

GENERAL RECOMMENDATIONS

LUBRICATION CHART

The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain snow thrower as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your snow thrower.

At least once a season, check to see if you should make any of the adjustments described in the Service and Ad- justments section of this manual.

•At least once a year, you should replace the spark plug and check belts for wear. A new spark plug will help your engine run better and last longer.

•Follow the maintenance schedule in this manual.

NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this unit. Failure to do so can cause the unit to malfunction and pose a risk of injury to the operator.

BEFORE EACH USE

1.Check engine oil level.

2.Check for loose fasteners.

3.Check controls to be sure they are functioning properly.

LUBRICATION

Keep your snow thrower well lubricated (See “LUBRICATION CHART”).

➀SAE 30 Motor Oil

➁See “ENGINE” in Maintenance section

➀Pivot points

➁Engine oil

SNOW THROWER

Always observe the safety rules when performing any maintenance.

TRACKS

•Keep track belt free of gasoline / oil, which can harm rubber.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Operator’s Manual Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Skid PlatesAssembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerRemove Snow Thrower from Carton Unfold Upper HandleInstall Traction Drive Control ROD See Figs Install Auger Control ROD See FigsInstall Chute Deflector Remote Control See Figs Install Discharge Chute / Chute Rotator Head See FigCheck Tire Pressure Operation Know Your Snow ThrowerMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineTransport and Height Adjustment of Snow Thrower SET Height Adjustment See FigsTo Transport See Figs Packed Snow Normal Operation Transport FloatHOW to USE Your Snow Thrower StoppingTo Throw Snow See Fig Using the CLEAN-OUT Tool See FigTo Move Forward and Backward See Fig Before Starting the Engine To TransportADD Gasoline See Fig To Start EngineCold Start Electric Starter Warm Start Electric StarterSnow Throwing Tips Warm Start Recoil StarterBefore Stopping If Recoil Starter has FrozenMaintenance General RecommendationsBefore Each USE LubricationCleaning EngineService and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See FigTo Replace Belts See Fig To Adjust Cable Tension See Fig To Adjust Traction Belt and Auger Belt TensionTo Remove Tracks See Fig CarburetorInstructions for Adjusting Power Steering Cables See Figs Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below 06/17/2014 TH
Top Page Image Contents