Husqvarna 96193002300 manual Storage, Other

Page 18

TO REMOVE WHEELS (See Fig. 25)

•Remove the bolt and nut; remove wheel from axle.

NOTE: To seal punctures or prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

BOLT

WHEEL

 

AXLE

NUT

WHEEL HUB

FIG. 25

ENGINE

See engine manual.

CARBURETOR

Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 7,000 feet (2,134 meters). If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center.

ENGINE SPEED

Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the engine-governed high speed needs adjusting, contact a qualified service center, which has proper equipment and experience to make any necessary adjustments.

STORAGE

Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.

WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. Allow the engine to cool before storing in any enclosure.

SNOW THROWER

When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire snow thrower (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See “TO RE- PLACE BELTS” in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

ENGINE

See engine manual.

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

•Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in min- imizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

3.Pull recoil starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

•Remove safety ignition key; store it in a safe place.

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your snow thrower indoors and cover it to protect it from dust and dirt.

•Cover your snow thrower with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe, which allows condensation to form and will cause your snow thrower to rust.

IMPORTANT: Never cover snow thrower while engine/ exhaust area is still warm.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents SBE OV Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper HandleInstall Traction Drive Control ROD See Figs Install Auger Control ROD See FigsInstall Discharge Chute / Chute Rotator Head See Fig Install Chute Deflector Remote Control See FigsCheck Tire Pressure Primer OperationKnow Your Snow Thrower Ignition KEYMeets A.N.S.I. Safety Requirements Discharge chute control lever used to change the diHOW to USE Your Snow Thrower StoppingTo Adjust Skid Plates See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Move Forward and Backward See FigScraper BAR see Fig Before Starting the EngineCheck Engine OIL Level See Fig To USE Drift Cutters See FigBefore Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has FrozenBefore Each USE MaintenanceGeneral Recommendations LubricationCleaning Snow ThrowerEngine Chute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Storage OtherTroubleshooting Repair Parts KEY Part Description Control Panel / Discharge Chute KEY Part Description Handles Repair Parts Drive 532 41 Chassis / Engine / Pulleys Repair Parts Wheels / Decals 532 41 76-91 Wheel Assembly Warranty Statement

96193002300 specifications

The Husqvarna 96193002300 is a premium lawn mower known for its exceptional performance, durability, and advanced technology, making it an excellent choice for homeowners and professional landscapers alike. This mower combines innovation with user-friendly features, providing a seamless mowing experience.

One of the standout features of the Husqvarna 96193002300 is its powerful engine, which ensures reliable performance across various terrains. The engine is engineered for efficiency, offering strong torque while consuming less fuel. This not only translates to longer mowing times but also reduces the frequency of refueling, making it an economical choice for regular maintenance of your lawn.

The mower boasts a robust cutting deck that enhances its cutting capabilities. The wide deck design allows for a greater cutting swath, enabling faster mowing of larger areas. Additionally, the adjustable cutting height is another significant feature, allowing users to customize their mowing to achieve the desired lawn appearance. This versatility caters to different grass types and conditions, ensuring that the lawn is maintained to perfection.

Equipped with advanced technology, the Husqvarna 96193002300 offers a user-friendly interface that enhances the overall mowing experience. The intuitive controls and ergonomic handles provide comfort during prolonged use. The mower’s self-propelled functionality means that users can navigate across uneven ground with minimal effort, a feature that is particularly beneficial for those with larger properties or challenging landscapes.

Moreover, the Husqvarna 96193002300 incorporates innovative safety features that prioritize user protection. These include safety switches that stop the blade when the user releases the handle and a robust frame construction that minimizes vibrations, ensuring a steady grip and control during operation.

For added convenience, the mower features easy-to-access maintenance points, making it simple to keep the machine in peak condition. Regular maintenance is crucial for longevity, and Husqvarna has designed this model with the user in mind.

In conclusion, the Husqvarna 96193002300 is a top-notch lawn mower that excels in performance, features, and safety. Its combination of power, efficiency, and user-friendly technology makes it a leading choice for anyone serious about lawn care, providing excellent results season after season. Whether you are a homeowner seeking to maintain a pristine lawn or a professional landscaper looking for reliable equipment, this mower stands out as a valuable investment.
Top Page Image Contents