Husqvarna 924SB, 96193004500 manual Safe Operation Practices for Walk-Behind Snow Throwers

Page 2

IMPORTANT

Safe Operation Practices for Walk-Behind Snow Throwers

This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury.

Look for this symbol to point out im- portant safety precautions. It means CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in order to prevent acci- dental starting when setting up, trans- porting, adjusting or making repairs.

WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surfaces. Caution should be exercised while using on sloping sur- faces. Do not use snow thrower on surfaces above ground level such as roofs of residences, garages, porches or other such structures or buildings.

WARNING: Snow throwers have ex- posed rotating parts, which can cause severe injury from contact, or from ma- terial thrown from the discharge chute. Keep the area of operation clear of all persons, small children and pets at all times including startup.

CAUTION: Muffler and other engine parts become extremely hot during operation and remain hot after engine has stopped. To avoid severe burns on contact, stay away from these areas.

WARNING: Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemi- cals known to the State of California to cause cancer and birth defects or other reproductive harm.

Training

1. Read, understand and follow all instructions on the

 

(f) Keep the nozzle in contact with the rim of the fuel

machine and in the manual(s) before operating this

 

tank or container opening at all times, until refuel-

unit. Be thoroughly familiar with the controls and the

 

ing is complete. Do not use a nozzle lock-open

proper use of the equipment. Know how to stop the

 

device.

unit and disengage the controls quickly.

 

(g) Replace gasoline cap securely and wipe up spilled

2. Never allow children to operate the equipment. Never

 

fuel.

allow adults to operate the equipment without proper

 

(h) If fuel is spilled on clothing, change clothing im-

instruction.

 

 

mediately.

3. Keep the area of operation clear of all persons, par-

 

5. Use extension cords and receptacles as specified by

ticularly small children.

 

the manufacturer for all units with electric drive motors

 

 

 

4. Exercise caution to avoid slipping or falling, especially

 

or electric starting motors.

when operating the snow thrower in reverse.

6. Adjust the collector housing height to clear gravel or

Preparation

 

crushed rock surface.

7. Never attempt to make any adjustments while the

1. Thoroughly inspect the area where the equipment is

 

engine (motor) is running (except when specifically

to be used and remove all doormats, sleds, boards,

 

recommended by manufacturer).

wires, and other foreign objects.

8. Always wear safety glasses or eye shields during op-

2. Disengage all clutches and shift into neutral before

 

eration or while performing an adjustment or repair to

starting the engine (motor).

 

protect eyes from foreign objects that may be thrown

3. Do not operate the equipment without wearing adequate

 

from the machine.

winter garments. Avoid loose fitting clothing that can

Operation

get caught in moving parts. Wear footwear that will

improve footing on slippery surfaces.

1. Do not put hands or feet near or under rotating parts.

4. Handle fuel with care; it is highly flammable

 

Keep clear of the discharge opening at all times.

(a)

Use an approved fuel container.

2. Exercise extreme caution when operating on or cross-

(b)

Never add fuel to a running engine or hot en-

 

ing gravel drives, walks, or roads. Stay alert for hidden

 

hazards or traffic.

 

gine.

 

 

3.

After striking a foreign object, stop the engine (motor),

(c) Fill fuel tank outdoors with extreme care. Never fill

 

remove the wire from the spark plug, disconnect the

 

fuel tank indoors.

 

 

 

cord on electric motors, thoroughly inspect the snow

(d) Never fill containers inside a vehicle or on a truck

 

 

thrower for any damage, and repair the damage before

 

or trailer bed with a plastic liner. Always place

 

restarting and operating the snow thrower.

 

containers on the ground, away from your vehicle,

4. If the unit should start to vibrate abnormally, stop the

 

before filling.

 

 

engine (motor) and check immediately for the cause.

(e)

When practical, remove gas-powered equipment

 

 

Vibration is generally a warning of trouble.

 

from the truck or trailer and refuel it on the ground.

5.

Stop the engine (motor) whenever you leave the oper-

 

If this is not possible, then refuel such equipment

on a trailer with a portable container, rather than

 

ating position, before unclogging the collector/impeller

 

housing or discharge chute, and when making any

from a gasoline dispenser nozzle.

 

2

repairs, adjustments or inspections.

 

 

 

Page 1 Page 3
Image 2
Page 1 Page 3
Contents 924SB Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Remove Snow Thrower from CartonUnfold Upper Handle Install Speed Control ROD See FigsInstall Traction Drive Control ROD See Figs Check Tire Pressure Install Auger Control ROD See FigsInstall Discharge Chute / Chute Rotater Head See Fig Primer OperationKnow Your Snow Thrower Ignition KEYMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineTo USE Fuel SHUT-OFF Valve See Fig HOW to USE Your Snow ThrowerStopping To USE Choke Control See FigTo Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig Scraper BAR See Fig To Adjust Skid Plates See FigBefore Starting the Engine Check Engine OIL Level See FigBefore Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has FrozenBefore Each USE MaintenanceGeneral Recommendations LubricationCleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Carburetor To Adjust Cable Tension See FigTo Remove Wheels See Fig Engine SpeedFuel System StorageOther Engine OILTroubleshooting Warranty Statement

96193004500, 924SB specifications

The Husqvarna 924SB, model number 96193004500, is a powerful snow blower designed for efficiency and performance in the toughest winter conditions. Adorned with a robust and innovative design, this snow blower is built for homeowners seeking reliable snow-clearing solutions for driveways, sidewalks, and other areas prone to heavy snowfall.

One of the key features of the Husqvarna 924SB is its powerful engine, equipped with a 24-inch clearing width and a 23-inch intake height. This allows for the removal of snow quickly and effectively, making it suitable for moderate to heavy snowfall. The engine boasts a reliable starting system, ensuring that the snow blower is ready to go even in frigid temperatures.

The 924SB employs a two-stage snow throwing system, which allows for efficient snow removal by utilizing an auger to gather snow before throwing it out through a chute. This system enhances its capability to tackle compacted and heavy snow, ensuring that users can maintain clean pathways with ease.

Another remarkable aspect of the Husqvarna 924SB is its adjustable chute, allowing users to direct the thrown snow precisely where it is needed, reducing the chances of creating hazards or blocking pathways. The auger height can also be adjusted to accommodate varying snow conditions, providing versatile performance whether dealing with light powder snow or heavy, wet snowfall.

The snow blower features a reliable, user-friendly control panel that allows for easy operation. The ergonomic handle provides comfort during extended use, with heated grips being a notable addition that enhances user comfort during cold winter days. The machine is also designed with durability in mind, featuring a solid, rugged construction to withstand the demanding tasks of snow removal.

With its impressive features, the Husqvarna 924SB delivers exceptional performance, making it an invaluable tool for homeowners facing harsh winter weather. Its combination of power, advanced technology, ease of use, and reliability positions it as a top choice in the snow blower market, ensuring users can enjoy a safe, clear, and accessible outdoor space during winter months. Whether facing light flurries or severe storms, the Husqvarna 924SB proves to be a steadfast companion against winter's challenges.
Top Page Image Contents