Husqvarna 9027STE owner manual Before Starting the Engine, Scraper BAR, To Start Engine

Page 12

OPERATION

TO ADJUST SKID PLATES (See Fig. 20)

NOTE: The wrench provided in your parts bag may be used to adjust the skid plates.

Skid plates are located on each side of the auger housing and adjust the clearance between the scraper bar and the ground surface. Adjust skid plates evenly to proper height for current surface conditions. For removal of snow in normal conditions, such as a paved driveway or sidewalk, place skid plates in the highest position (lowest scraper clearance) to give a 1/8" clearance between the scraper bar and the ground. Use a middle position if the surface to be cleared is uneven.

NOTE: It is not recommended to operate the snow thrower over gravel or rocky surfaces. Objects such as gravel, rocks or other debris, can easily be picked up and thrown by the impeller, which can cause serious personal injury, property damage or damage to the snow thrower.

•If snow thrower must be operated over gravel surface, use extra caution and be sure skid plates are adjusted to lowest (highest scraper clearance) position.

1.Shut off engine and wait for all moving parts to stop.

2.Adjust skid plates by loosening the rear 1/2" hex nut only, then moving skid plate to desired position.Be sure both plates are adjusted evenly. Tighten securely.

HIGH POSITION (LOW GROUND CLEARANCE)

AUGER

HOUSING

SKID PLATE

1/2" HEX NUT

LOW POSITION (HIGH GROUND CLEARANCE)

FIG. 20

SCRAPER BAR

The scraper bar is not adjustable, but is reversible. After considerable use it may become worn. When it has worn almost to the edge of the housing, it can be reversed, providing additional service before requiring replacement. Replace a damaged or worn scraper bar.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL (See Fig. 21)

The engine on your snow thrower has been shipped, from the factory, already filled with oil.

1.Check engine oil with snow thrower on level ground.

2.Remove oil fi ll cap/dipstick and wipe clean, reinsert the dipstick and screw tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•To change engine oil, see “TO CHANGE ENGINE OIL” in the Maintenance section of this manual.

ADD GASOLINE (See Fig. 21)

•Fill fuel tank to bottom of tank fi ller neck. Do not over- fill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30

days to assure fuel freshness.

12

WARNING: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can at- tract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

CHOKE CONTROL

THROTTLE PRIMER ENGINE OIL

 

FILL CAP /

 

DIPSTICK

SAFETY

IGNITION

KEY

 

GASOLINE

 

FILLER CAP

 

FUEL SHUT-

 

OFF VALVE

RECOIL

STARTER BUTTON

STARTER

 

HANDLE

POWER CORD PLUG

NOTE: ALL ITEMS ARE SHOWN IN THEIR TYPICAL LOCATION. ACTUAL LOCATION MAY VARY WITH ENGINE ON YOUR UNIT.

FIG. 21

TO START ENGINE

•Be sure fuel shut-off valve is in the OPEN position.

Your snow thrower engine is equipped with both a 120 Volt A.C. electric starter and a recoil starter. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A.C. household current.

•Be sure your house is a 120 Volt A.C. three-wire grounded system. If you are uncertain, consult a licensed electrician.

WARNING: Do not use the electric starter if your house is not a 120 Volt A.C. three-wire grounded system. Se- rious personal injury or damage to your snow thrower could result.

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 9027STE XP Training PreparationOperation Static Electricity HazardMaintenance and Storage API SG-SLService and Adjustments Parts Packed Separately in Carton14-15 16-18Assembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerRemove Snow Thrower from Carton Unfold Upper HandleInstall Auger Control ROD See Figs Install Discharge Chute / Chute Rotater Head See FigInstall Chute Deflector Remote Control See Figs Install Weight BAR See FigCheck Tire Pressure Operation Know Your Snow ThrowerMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineHOW to USE Your Snow Thrower StoppingUsing the CLEAN-OUT Tool See Fig Power Steering Operation See FigTo Throw Snow See Fig To Move Forward and Backward See FigBefore Starting the Engine Scraper BARTo Start Engine Snow Throwing Tips Before StoppingIf Recoil Starter has Frozen Maintenance General RecommendationsBefore Each USE LubricationCleaning EngineService and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See FigTo Replace Belts See Fig Storage OtherTroubleshooting Repair Parts Auger Housing / Impeller Assembly KEY Part Description Repair Parts Repair Parts Repair Parts Handles Handles Drive Repair Parts Chassis / Engine / Pullys KEY Part Description Repair Parts Wheels / Decals Wheels / Decals Rantywar Tementsta Sion Tmita ILD NA SON ITP Eexc 4ON ITC ES

9027STE specifications

The Husqvarna 9027STE is a powerful and versatile lawn mower designed specifically for tackling challenging terrains and delivering a superior cutting experience. Built with robust features and advanced technologies, this machine stands out in the competitive market of outdoor power equipment.

One of the key attributes of the 9027STE is its efficient cutting system. It boasts a wide cutting deck that allows for faster mowing, reducing the time spent on lawn care. The cutting height is conveniently adjustable, enabling users to customize the grass length to their preference. With its durable blades, the mower provides a clean, sharp cut, promoting healthy grass growth and an aesthetically pleasing lawn.

Powered by a reliable engine, the Husqvarna 9027STE offers exceptional performance and longevity. Its efficient engine design ensures low fuel consumption while still delivering ample power for tackling tough grass and uneven terrain. This enhances the mower’s capability to operate over large areas without frequent refueling, making it ideal for large properties or commercial use.

Incorporating advanced technology, the 9027STE features ergonomic controls that improve user comfort and ease of operation. The intuitive control layout allows for effortless maneuvering, reducing operator fatigue during prolonged use. The lawn mower's compact design further enhances its maneuverability, enabling users to navigate around obstacles and tight spaces with ease.

Safety is a priority with the Husqvarna 9027STE, which is equipped with various safety features including an automatic shut-off mechanism that engages when the mower is not in use, preventing accidental starts. This adds an extra layer of protection for the operator, especially when working in proximity to children or pets.

Another standout characteristic of the 9027STE is its durability. Made from high-quality materials, the mower is built to withstand the rigors of regular use and is resistant to wear and tear, ensuring a long lifespan. Moreover, the model is easy to maintain, with readily accessible components making it simple for users to service and keep in optimal condition.

Overall, the Husqvarna 9027STE is a top-tier choice for those seeking a reliable, efficient, and user-friendly lawn mower. Its combination of power, advanced features, and durability makes it an investment worth considering for both residential and commercial lawn care needs. Whether you're a homeowner maintaining a lush garden or a professional landscaper, the 9027STE promises to deliver impressive results and convenience.
Top Page Image Contents