Husqvarna 9027STE owner manual Storage, Other

Page 18

TO REMOVE WHEELS (See Fig. 25)

•Remove the klik pin and remove wheel from axle.

IMPORTANT: When installing wheel, be sure to use the axle hole closest to the end of the shaft – do not use the hole in the wheel hub (if equipped). Inner hole in axle and hole in wheel hub are not used for your model snow thrower.

KLIK PIN (INSTALL

OUTER HOLE

IN OUTER HOLE

 

OF AXLE ONLY)

 

AXLE

WHEEL

WHEEL HUB

FIG. 25

NOTE: To seal punctures or prevent fl at tires due to slow leaks, tire sealant may be purchased from your local parts dealer.Tire sealant also prevents tire dry rot and corrosion.

ENGINE

See engine manual.

CARBURETOR

Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 7,000 feet (2,134 meters). If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center.

ENGINE SPEED

Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the engine-governed high speed needs adjusting, contact a qualifi ed service center, which has proper equipment and experience to make any necessary adjustments.

STORAGE

Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.

WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. Allow the engine to cool before storing in any enclosure.

SNOW THROWER

When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire snow thrower (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See “TO RE- PLACE BELTS”in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

ENGINE

See engine manual.

FUEL SYSTEM

 

IMPORTANT: It is important to prevent gum deposits from

 

forming in essential fuel system parts such as carburetor,

 

fuel hose, or tank during storage.Also, alcohol blended fuels

 

(called gasohol or using ethanol or methanol) can attract

 

moisture which leads to separation and formation of acids

 

during storage. Acidic gas can damage the fuel system of

 

an engine while in storage.

18

 

•Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in min- imizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

3.Pull recoil starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your snow thrower indoors and cover it to protect it from dust and dirt.

•Cover your snow thrower with a suitable protective cover that does not retain moisture.Do not use plastic.Plastic cannot breathe, which allows condensation to form and will cause your snow thrower to rust.

IMPORTANT: Never cover snow thrower while engine/ exhaust area is still warm.

Page 17 Page 19
Image 18
Page 17 Page 19
Contents 9027STE XP Operation TrainingPreparation Static Electricity HazardMaintenance and Storage API SG-SL14-15 Service and AdjustmentsParts Packed Separately in Carton 16-18Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper HandleInstall Auger Control ROD See Figs Install Discharge Chute / Chute Rotater Head See FigInstall Chute Deflector Remote Control See Figs Install Weight BAR See FigCheck Tire Pressure Operation Know Your Snow ThrowerMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineHOW to USE Your Snow Thrower StoppingTo Throw Snow See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Move Forward and Backward See FigBefore Starting the Engine Scraper BARTo Start Engine Snow Throwing Tips Before StoppingIf Recoil Starter has Frozen Before Each USE MaintenanceGeneral Recommendations LubricationCleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Storage OtherTroubleshooting Repair Parts Auger Housing / Impeller Assembly KEY Part Description Repair Parts Repair Parts Repair Parts Handles Handles Drive Repair Parts Chassis / Engine / Pullys KEY Part Description Repair Parts Wheels / Decals Wheels / Decals Rantywar Tementsta Sion Tmita ILD NA SON ITP Eexc 4ON ITC ES

9027STE specifications

The Husqvarna 9027STE is a powerful and versatile lawn mower designed specifically for tackling challenging terrains and delivering a superior cutting experience. Built with robust features and advanced technologies, this machine stands out in the competitive market of outdoor power equipment.

One of the key attributes of the 9027STE is its efficient cutting system. It boasts a wide cutting deck that allows for faster mowing, reducing the time spent on lawn care. The cutting height is conveniently adjustable, enabling users to customize the grass length to their preference. With its durable blades, the mower provides a clean, sharp cut, promoting healthy grass growth and an aesthetically pleasing lawn.

Powered by a reliable engine, the Husqvarna 9027STE offers exceptional performance and longevity. Its efficient engine design ensures low fuel consumption while still delivering ample power for tackling tough grass and uneven terrain. This enhances the mower’s capability to operate over large areas without frequent refueling, making it ideal for large properties or commercial use.

Incorporating advanced technology, the 9027STE features ergonomic controls that improve user comfort and ease of operation. The intuitive control layout allows for effortless maneuvering, reducing operator fatigue during prolonged use. The lawn mower's compact design further enhances its maneuverability, enabling users to navigate around obstacles and tight spaces with ease.

Safety is a priority with the Husqvarna 9027STE, which is equipped with various safety features including an automatic shut-off mechanism that engages when the mower is not in use, preventing accidental starts. This adds an extra layer of protection for the operator, especially when working in proximity to children or pets.

Another standout characteristic of the 9027STE is its durability. Made from high-quality materials, the mower is built to withstand the rigors of regular use and is resistant to wear and tear, ensuring a long lifespan. Moreover, the model is easy to maintain, with readily accessible components making it simple for users to service and keep in optimal condition.

Overall, the Husqvarna 9027STE is a top-tier choice for those seeking a reliable, efficient, and user-friendly lawn mower. Its combination of power, advanced features, and durability makes it an investment worth considering for both residential and commercial lawn care needs. Whether you're a homeowner maintaining a lush garden or a professional landscaper, the 9027STE promises to deliver impressive results and convenience.
Top Page Image Contents