Troubleshooting
See appropriate section in manual unless directed to an authorized service center/department.
PROBLEM |
| CAUSE |
| CORRECTION |
Does not start | 1. | Fuel | 1. | Turn fuel |
|
| equipped) in OFF position. |
|
|
| 2. | Safety ignition key | 2. | Insert safety ignition key. |
|
| is not inserted. |
|
|
| 3. | Out of fuel. | 3. | Fill fuel tank with fresh, clean gasoline. |
| 4. | Throttle in STOP position | 4. | Move throttle to FAST position |
|
| (or ON/OFF switch is OFF). |
| (or ON/OFF switch to ON position). |
| 5. | Choke in OFF position. | 5. | Move to FULL position. |
| 6. | Primer not depressed. | 6. | Prime as instructed in the Operation section of this manual. |
| 7. | Engine is flooded. | 7. | Wait a few minutes before restarting, DO NOT prime. |
| 8. | Spark plug wire is | 8. | Connect wire to spark plug. |
|
| disconnected. |
|
|
| 9. | Bad spark plug. | 9. | Replace spark plug. |
| 10. | Stale fuel. | 10. | Empty fuel tank & carburetor, refill with fresh, clean gasoline. |
| 11. | Water in fuel. | 11. | Empty fuel tank & carburetor, refill with fresh, clean gasoline. |
|
|
|
|
|
Loss of power | 1. | Spark plug wire loose. | 1. | Reconnect spark plug wire. |
| 2. | Throwing too much snow. | 2. | Reduce speed and width of swath. |
| 3. | Fuel tank cap is covered | 3. | Remove ice and snow on and around fuel tank cap. |
|
| with ice or snow. |
|
|
| 4. | Dirty or clogged muffler. | 4. | Clean or replace muffler. |
| 5. | Improper cable length. | 5. | Adjust cable. |
|
|
|
|
|
Engine idles or | 1. | Choke is in FULL position. | 1. | Move choke to OFF position. |
runs roughly | 2. | Blockage in fuel line. | 2. | Clean fuel line. |
| 3. | Stale fuel. | 3. | Empty fuel tank & carburetor, refill with fresh, clean gasoline. |
| 4. | Water in fuel. | 4. | Empty fuel tank & carburetor, refill with fresh, clean gasoline. |
| 5. | Carburetor is in need of | 5. | Contact an authorized service center/department. |
|
| adjustment or overhaul. |
|
|
|
|
|
|
|
Excessive | 1. | Loose parts or damaged | 1. | Tighten all fasteners. Replace damaged parts. If vibration |
vibration |
| augers or impeller. |
| remains, contact an authorized service center/department. |
|
|
|
|
|
Recoil starter | 1. | Frozen recoil starter. | 1. | See “IF RECOIL STARTER HAS FROZEN” |
is hard to pull |
|
|
| in the Operation section of this manual. |
|
|
|
|
|
Loss of traction | 1. | Drive belt is worn. | 1. | Check / replace drive belt. |
drive / slowing | 2. | Drive belt is off of pulley. | 2. | Check / reinstall drive belt. |
of drive speed | 3. | Auger blades worn. | 3. | Contact an authorized service center/department. |
|
|
|
|
|
Loss of snow | 1. | Auger belt is off of pulley. | 1. | Check / reinstall auger belt. |
discharge or | 2. | Auger belt is worn. | 2. | Check / replace auger belt. |
slowing of | 3. | Clogged discharge chute. | 3. | Clean snow chute. |
snow discharge | 4. | Augers / impeller jammed. | 4. | Remove debris or foreign object from augers / impeller. |
|
|
|
|
|
17