McCulloch 96188000400 owner manual Setup, Unfolding the Handle, Installing the Discharge Chute

Page 5

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure

Description

Qty.

Use

1.

No parts required

Unfold the handle.

 

 

 

2.

Carriage bolts

5

Install the discharge chute.

Flange nuts

4

Install the discharge chute.

 

 

Washers

2

Install the discharge chute.

 

Knob

1

Install the discharge chute.

 

Chute

1

 

 

Deflector

1

 

 

 

 

 

1. Unfolding the Handle

Procedure

1.Loosen the two handle knobs and pull out the two handle bolts until you can move the handle freely and rotate the handle to the operating position (Figure 2).

1

2

Figure 2

1. Handle knobs

2. Handle bolt

2. Tighten the handle knobs until they are snug (Figure 3).

2.Installing the Discharge Chute

5Carriage bolts

4Flange nuts

2

Washers

 

 

1

Knob

 

 

1

Chute

1

Deflector

Procedure

Install the discharge chute as shown (Figure 4).

1

3

4

4

5

2

3

6

 

 

Figure 4

 

1. Deflector

4.

Washer

2.

Carriage bolts

5.

Knob

3.

Flange nuts

6.

Discharge chute

Figure 3

IMPORTANT: Do not overtighten the flange nuts;

5

otherwise you may damage the discharge chute.

 

Image 5
Contents MC621ES Safe Operation Practices for Walk-Behind Snow Throwers Come ALERT!!! Your Safety is InvolvedF6RTC Shut the Engine OFFAPI SG-SL Table of Contents Unfolding the Handle SetupInstalling the Discharge Chute Lubrication Filling the Engine with Oil Product OverviewChecking the Engine Oil Level OperationFilling the Fuel Tank Starting the Engine Disengaging the Auger Blades Engaging the Auger BladesStopping the Engine Adjusting the Discharge Chute and Chute DeflectorClearing a Clogged Discharge Chute Preventing Freeze-up after UseOperating Tips MaintenanceInspecting the Auger Blades Adjusting the Control CableChanging the Engine Oil Servicing the Spark Plug Replacing the Drive Belt Fuel System Storage Storing the SnowthrowerEngine OIL CylinderDoes not start TroubleshootingSSST-Chute asm5 KEY Part QTY Description HANDLE.PNT.UPPER.SSST BAIL.HANDLE.PAINT.MS431CONTROL.CABLE KNOB.HANDLE.BLACKQTY Description KEY Part NO. noBOLT.CARRIAGE PLATE.CENTER.BLADE 13 HEX.NUT.1/4-20 Nylon LockingSSST-Shroud asm8 COVER.NON-DRIVE.SIDE.MS428 KEY HousingCOVER.DRIVE.SIDE.MS428 TOP.COVERSSST-Frame asm3 FRAME.WELDMENT LCT.ENGINEWHEEL.8X1.5.BRICK.GS.3SPK.MS421 NUT.PUSH.AXLE.0.5INKEEPER.ENGINE.BELT SPACER.ENGINE.CRANKPULLEY.ENG.TRACTION.3/4 WASHER.HARDENService Notes Repair Parts Snow Thrower - Model Number MC621ES ENGINE, LCT KEY Part Description Limited Warranty