Bolens 933 SWE, 930 SWE warranty Service, Belt Removal Preparation, Auger Belt Replacement

Page 18

Service

Belt Replacement

Belt Removal Preparation

1.Disconnect the chute crank assembly at the discharge chute end by removing the hairpin clip and the flat washer. Refer to Figure 7-1.

Figure 7-1

2.Remove the plastic belt cover on the front of the engine by removing the three self-tapping screws. See Fig. 7-2.

Figure 7-2

3.Loosen the bolt shown in Figure 7-3 securing the belt keeper bracket and remove the other bolt. Push the belt keeper bracket up off the engine pulley. Refer to Figure 7-3.

7

Remove

Loosen

Figure 7-3

Auger Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed as follows:

1.Remove the hairpin clip and flat washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly. See Figure 7-4.

NOTE: Make sure to maintain the location of the ferrule on the idler rod.

Figure 7-4

2.Slip the auger control belt (the front belt) off the engine pulley.

3.Pull the brake bracket assembly towards the cable guide roller and unhook the auger cable “Z” fitting. Refer to Figure 7-5.

18

Image 18

Contents Operator’s Manual JulyThank You Table of ContentsTo The Owner Record Product InformationImportant Safe Operation Practices California Proposition TrainingPreparation Operation Safe Handling of GasolineSpark Arrestor Maintenance & StorageDo not modify engine Average Useful LifeAssembly & Set-Up Contents of CartonAssembly Set-Up Shear PinsChute Clean-Out Tool Headlight HarnessAdjustments Auger and Drive Control Cables Testing Auger Drive ControlSkid Shoes Testing Drive Control & Shift Lever Gas & Oil Fill-UpChoke Control Controls and FeaturesShift Lever Ignition KeyThrottle Control Electric Starter SwitchChute Assembly Primer BulbChute Directional Control Chute Clean-Out ToolTwo-Way Chute Control Wheel Steering ControlsStopping The Engine OperationStarting The Engine Electric StarterTo Engage Augers Replacing Shear PinsTo Engage Drive Operating TipsMaintenance & Adjustments MaintenanceLubrication Shift Cable Chute Bracket AdjustmentAuger Shaft AugersDrive Control Auger ControlTire Pressure Auger Belt Replacement ServiceBelt Replacement Belt Removal PreparationPulley Slot Drive Belt Replacement Changing Friction WheelOff-Season Storage Short-Term StorageLong-Term Storage Troubleshooting Problem Cause RemedyReplacement Parts Component Description Part Number InchCUB Cadet LLC MANUFACTURER’S Limited Warranty for Snow throwers