| Auger Control |
Left | Left Bracket |
Handle |
|
Hex Lock Nut
Spacer
Hex Bolt
Handle Panel
“Z” Fitting
Figure 4
•Repeat process for the right side Traction Control.
•Lay handle assembly behind snow thrower. See Figure 5.
•Insert a hex bolt 3/4” long and lock washer through the lower hole on the bottom of the handle.
•Hold the handle assembly up to the bottom of the snow thrower frame and thread the hex bolt into the lower hole in snow thrower frame. Do not tighten at this time. See Figure 5.
•Repeat process on the other side.
|
| 2” Hex Bolt |
Saddle |
|
|
Cable Roller |
| |
Guide | Lock |
|
| 3/4” Hex | |
| Washers | |
|
| Bolt |
Figure 6
Attaching Shift Rod (Hardware D)
•Place the shift lever in the fastest forward speed position.
•Models 602, 642, and 662: Rotate the shift arm assembly counter clockwise, as far as it will go. Insert the shift rod through the shift arm assembly. When installed the shift arm assembly should point to the right. Secure with flat washer and hairpin clip. See Figure 7.
•Models 602, 642, and 662: Thread the ferrule up or down the shift rod and align with the lower hole on the shift lever assembly behind the handle panel. See Figure 7.
| Shift | Hairpin | Traction |
| Lever | Clip | Drive Clutch |
|
|
| |
Handle Panel & | Auger |
|
|
Drive Clutch |
|
| |
Handles |
|
| |
|
|
| |
| Ferrule |
|
|
| (Bottom Hole) |
| Flat Washer |
| Shift Rod |
|
|
Hex Bolt & |
| Flat |
|
| Washer |
| |
Lock Washer | Shift Arm |
| Hairpin |
|
| ||
Figure 5 |
| Clip | |
Assembly |
| ||
|
| ||
• Raise the handle assembly into the upright position |
|
|
|
and align the top holes in the handle with the top |
|
|
|
holes in the snow thrower frame. Attach using 2” | Models 602, 642 and 662 |
| |
long hex bolts, lock washers and saddles. (Curve in |
| ||
Figure 7 |
| ||
saddle must match the curve in the handle.) |
| ||
|
|
| |
See Figure 6. | • Models 614, 644, 664 and 6A4: Rotate the shift | ||
• Tighten all hardware used to attach the handle | arm assembly counter clockwise as far as it will go. | ||
assembly to the snow thrower frame. | Insert the shift rod through the shift arm assembly. | ||
| When installed, the shift arm assembly should point | ||
| left. Secure with flat washer and hairpin clip. | ||
| See Figure 8. |
|
|
| 7 |
|
|