Dell Understanding Internal Dual SD Module Redundancy and Status of IDSDM SD1 & SD2

Table 4-31. IDSDM Status

IDSDM - Mirror	SD1 Card	SD2 Card	vFlash SD Card
Mode
Enabled	Active	Active	Inactive
Disabled	Active	Inactive	Active

Using iDRAC you can view the status, health, and availability of IDSDM.

The SD card redundancy status and failure events are logged to SEL, displayed on LCD, and PET alerts are generated if alerts are enabled.

Viewing Internal Dual SD Module Status Using GUI

1Log in to the iDRAC Web GUI.

2Click Removable Flash Media. The Removable vFlash Media page is displayed. This page displays the following two sections:

•Internal Dual SD Module — Displayed only if IDSDM is in redundant mode. The Redundancy Status is displayed as Full. If this section is not present, then the card is in the non-redundant mode state. The valid Redundancy Status indications are:

–Full — SD card 1 and 2 are functioning properly.

–Lost — Either one of the SD card or both the SD cards are not functioning properly.

•Internal SD Module Status — Displays the SD card state for SD1, SD2, and vFlash cards with the following information:

–Status:

• — Indicates that the card is ok.

• — Indicates that the card is offline or write-protected.

• — Indicates that an alert is issued.

–Location — Location of the SD cards.

–Online Status — SD1, SD2, and vFlash cards can be in one of the states listed in Table 4-32.

Configuring the iDRAC6 Using the Web Interface

85